AVLink WVH-EPR Benutzerhandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Extender AVLink WVH-EPR herunter. AVLink WVH-EPR 3 Seiten. Hdmi/vga extender
Seite drucken
REAR VIEW
WVH-EPL
1. RS-232 Connector (1X3 Pole Captive Screw Socket)
2. DC 48V (1x2 Pole Captive Screw Socket)
3. Link (RJ-45 Connector)
WVH-EPR
1. RS-232 Connector (1X3 Pole Captive Screw Socket)
2. Link (RJ-45 Connector)
Installation
1. Turn off the HDMI source and HDMI display.
2. Connect the HDMI/VGA cable between the HDMI/VGA
source and the "HDMI/VGA IN" port of WVH-EPL.
3. Connect the HDMI cable between the HDMI display and
the "HDMI OUT" port of WVH-EPR.
4. Connect the CAT.5/5e/6 cables between the WVH-EPL
"LINK" port and the WVH-EPR "LINK" port of extender.
5. Connect the power cord of WVH-EPL.
5. Turn on the HDMI/VGA source and display.
-3-
IR Receiver Cable Directions:
Put it into the WVH-EPL/R "IR IN" port and place the IR
Receiver Cable, so that you can point to it easily with your
IR remote controller.
IR Blaster Cable Directions:
Plug IR blaster cable plug into WVH-EPL/R "IR OUT" port,
It sits in front of the DVD receiver's IR sensor, which is
located on the front-panel.
Technical Specifications Output Signal
Pin #
Signal
Pin #
1
TMDS Data 2+
11
2
12
TMDS Data 2 Shield
3
13
TMDS Data 2-
4
14
TMDS Data 1+
5
TMDS Data 1 Shield
15
6
16
TMDS Data 1-
7
17
TMDS Data 0+
8
TMDS Data 0 Shield
18
9
TMDS Data 0-
19
10
TMDS Clock+
-4-
Wiring Information & Coding
Conductor
Identification
Pair 1
Pair 2
Pair 3
Pair 4
TxGRx (only upgrade firmware)
Use the transmission line with RS-232 to connect the PC
for upgrade firmware(local and remote).
Signal
TMDS Clock Shield
Rx /G /Tx:
TMDS Clock -
Rx: Receive RS232-level signal pin. (data in)
CEC
G: GND
Reserved
Tx: Transmit RS232-level signal pin. (data out)
(N.C. on device)
SCL
SDA
DDC/CEC Ground
+5 Power
Hot Plug Detect
RJ-45 Pin
Color Code for
Assignment
Conductor
White-Blue
5
Blue
4
1
White-Orange
2
Orange
White-Green
3
Green
6
White-Brown
7
8
Brown
:
-5-