Dexter Laundry DRC55 Series Gebrauchsanweisung - Seite 12
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Trockner Dexter Laundry DRC55 Series herunter. Dexter Laundry DRC55 Series 12 Seiten. Dexter drc55 series dryers (25kg capacity)
Seite drucken
Put dryer in PROGRAM mode (see "Programming Instructions"). The dryer remains in the
PROGRAM mode until one of these actions occur:
•
The switch is actuated again.
•
The fifteenth step is completed, and the START switch is pushed following the fifteenth
step.
•
Programming is stopped for about a minute.
•
The loading door is closed.
Observe the displayed value in each step. If no change is required, press START to advance to
the next program step. If a change is required the values are made larger by the HOT button,
smaller by the PERM-PRESS button. The hour meter and money audit can be reset to zero if
WARM is pressed.
Note: After any reset or program change, it is necessary to advance to advance to the next step by
pressing START to enter the revision. OTHERWISE THE VALUE WILL REMAIN AS IT
WAS BEFORE THE ALTERATION.
1. Unlock and open the service door.
2. Open the loading door.
3. Push the Program Button found just to the left of the warm cycle light. The Button is
accessible through a hole in the control mounting plate after the removal of the bright metal plug.
4. The control switches to PROGRAM mode. In PROGRAM mode, the membrane switch
keypad becomes a 4-switch programming tool.
5. The ACTUAL NUMERICAL VALUES desired are in as explained in the table.
IMPORTANT: Please remember to push START to actually enter (store in memory) new data.
If you merely change the display, the memory has not been changed.
CHANGING PROGRAM DATA
PROGRAMMING INSTRUCTIONS:
(To switch to program mode.)
-12-