Dexter Laundry 400 EXPRESS Broschüre für den Besitzer - Seite 8

Blättern Sie online oder laden Sie pdf Broschüre für den Besitzer für Waschmaschine Dexter Laundry 400 EXPRESS herunter. Dexter Laundry 400 EXPRESS 13 Seiten. 25lb capacity computer control coin-op washer installation & operation instructions

Seite drucken

PROGRAMMING INSTRUCTIONS:

Programming can be accomplished manually using the machine controls or by connecting to the

machine control using a PDA (personal digital assistant). For instructions on using a PDA with

this washer control, please contact your local Dexter distributor. Please read below for manual

programming instructions.

The washer has two levels of programming. The Coin/Price Programming allows the owner to

set the price for the washer features and the values of the coins. The Washer Cycle Programming

allows the owner complete access to the wash cycle parameters – add/remove a bath, bath times,

spin times, water temperatures, etc. To enter the programming modes, the top of the washer must

be unlocked and slid toward the back of the washer a few inches.

COIN PRICE PROGRAMMING

While the washer is in the Idle mode, push the Programming pushbutton on the controller. The

Idle mode is when the washer is not running a cycle and the price of the bath is displayed. The

Programming pushbutton is a very small buttoned located on the upper center of the controller

directly behind the display. There are six stages in the Coin/Price Programming mode.

To step through to the desired stage, repeatedly push the right-hand Warm temperature

button until the desired stage is blinking on the display. To exit the Coin/Price

programming mode, push and hold the Cold temperature button for 5 seconds.

Stage 1: Right Coin – The display will blink first a "r" indicating right coin and then a coin value

($1.00 – default). The display will blink back and forth between the "r" and the value. To

change the value, use the Hot temperature button to decrease and the left-hand Warm

temperature button to increase. The value will change in 5¢ steps. The range of values is from

$00.00 to $99.95. When the desired right coin value is displayed, push the right-hand Warm

temperature button once to store the new value and a second time to move to the next Coin/Price

programming step.

To exit the Coin/Price programming mode, push the Cold temperature button for 5 seconds.

Stage 2: Left Coin – The display will blink first a "L" indicating left coin and then a coin value

($0.25– default). The display will blink back and forth between the "L" and the value. To

change the value, use the Hot temperature button to decrease and the left-hand Warm

temperature button to increase. The value will change in 5¢ steps. The range of values is from

$00.00 to $99.95. When the desired left coin value is displayed, push the right-hand Warm

temperature button once to store the new value and a second time to move to the next Coin/Price

programming step. To exit the Coin/Price programming mode, push the Cold temperature button

for 5 seconds.

Stage 3: Wash Price – The display will blink first a "P" indicating wash price and then present

wash price. The display will blink back and forth between the "P" and the price. To change the

value, use the Hot temperature button to decrease and the left-hand Warm temperature button to

increase. The value will change in 5¢ steps. The range of values is from $00.05 to $99.95.

When the desired price is displayed, push the right-hand Warm temperature button once to store

the new value and a second time to move to the next Coin/Price programming step. To exit the