Aqua Creek Scout 2 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Hebesysteme Aqua Creek Scout 2 herunter. Aqua Creek Scout 2 17 Seiten. Pool lift

Anchor Installation: Core-drill Retro-fit

Place the anchor in the hole and 'dry-fit' it first to make sure the anchor will be flush and

plumb with the finished deck surface when installed. Adjust the hole as needed.

NOTE: Pool decks with pavers or thick tiles may require other anchor options. Contact Aqua Creek Products.

Inject epoxy adhesive into each hole starting at the bottom until the hole is 1/3 to 1/2 full.

NOTE: We recommend using masking tape around the top of the anchors so that no epoxy gets inside the anchors.

1/2" X 2"

HEX BOLT &

FLAT WASHER

FIXING ANCHOR-TAB

Install the anchor into the epoxy filled hole by pushing down and twisting back and

forth to evenly distribute the epoxy around the anchor. Push down until it is flush with the

finished deck surface. Clean off any excess epoxy. Adjust the anchor as needed to make

sure it is flush and plumb with the deck surface. This should be done during the adhesives'

specified 'gel time' (see epoxy manufacturers' instructions).

Let the epoxy cure for at least 24 hours before installing the lift (or where applicable ac-

cording to the epoxy manufacturers' instructions).

1" X 4"

FIXING-

ANCHOR

FIGURE A

SCOUT MAIN ASSEMBLY

1.9" POST

1.9" X 6" ANCHOR

(AQUA CREEK OR EQUIVALENT)

ANCHOR MUST BE BONDED

ACCORDING TO LOCAL

REQUIREMENTS

(CONTINUED)

Revised 6/8/18