A.H. Systems AK-18G Betriebshandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Antenna A.H. Systems AK-18G herunter. A.H. Systems AK-18G 10 Seiten. Antenna kit

A.H. Systems AK-18G Antenna Kit

CURRENT PROBES

BCP-610 LF Current Probe 20 Hz - 20 MHz

BCP-611 HF/VHF Current Probe 10 kHz - 150 MHz

The current probes come ready for use.

Operation: The two current probes measure conducted emissions when clamped

around a single conductor, cable or a bundle of conductors. Disconnect the probe

latch Position the probe around the conductor and close the probe. Reconnect the

probe latch to ensure that the probe is tightly closed. Connect the probe connector

to the receiver with a cable. The probe calibrations supplied are into a 50-ohm

receiver.

TRIPOD AND MOUNTING ADPTERS

ATU-510 Tripod

AEH-510 Azimuth and Elevation Head

The azimuth and elevation head (AEH-510) mounts to the tripod (ATU-510) top

and allows the antennas to be rotated 360 degrees and tilted between horizontal

and vertical polarization. The tripod and azimuth and elevation head come in their

own carrying case. Each tripod leg is independently adjustable in angle and length

to facilitate antenna height setting. The tripod legs have a rubber tip on one end for

indoor or hard surface use, and a metal spike on the other end for outdoor soft

surface (such as dirt) use.

TRANSIT STORAGE CASES

TCC-510 Tripod Carrying Case

TSC-542 Transit Storage Case

The antenna carrying case (TSC-542) prevents damage and loss of antennas

when storing or transporting the antenna kit. The case is constructed of lightweight

and durable polyethylene. Two case keys are provided with the case.

OPTIONAL EQUIPMENT

The AK-40G case comes with three additional cutouts for optional preamplifiers.

In order to improve overall system sensitivity, the following equipment will be

required:

PAM-0118P Preamplifier 20 MHz – 18 GHz

The preamplifier will increase the system sensitivity 37 dB and is recommend for

the SAS-510-2, SAS-530,542 and SAS-571. An optional short length cable (SAC-

18G-0.5), is required to connect the preamplifier to any 50-ohm receiver or

spectrum analyzer.

REV C

•

PAM-0118 with an SAC-18G-0.5

•

PAM-1840 with an SAC-40G-0.5