Aqua Creek Products REVOLUTION F-702RLNA-SPA Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Handbuch für Hebesysteme Aqua Creek Products REVOLUTION F-702RLNA-SPA herunter. Aqua Creek Products REVOLUTION F-702RLNA-SPA 16 Seiten. Revolution spa lift
Auch für Aqua Creek Products REVOLUTION F-702RLNA-SPA: Handbuch (18 seiten)

Aqua Creek Products REVOLUTION F-702RLNA-SPA Handbuch
STEP 2: INSTALL LIFTING ARM
Locate the LIFTING ARM and the following hardware:
(1) 1/2" x 2-3/4" SHOULDER BOLT
(1) 3/8" x 2" SHOULDER BOLT
(1) 5/16" FLAT WASHER
(1) 5/16" NYLOCK NUT
(1) 3/8" FLAT WASHER
(1) 3/8" NYLOCK NUT
Remove the shipping strap and all packing from
the LINEAR ACTUATOR. Connect the LIFTING ARM
between the MAST and the LINEAR ACTUATOR as
shown in the fi gure below. Make sure the end marked
"B" attaches to the mast. Tighten NYLOCK NUTS (2)
until snug as shown in PHOTO 2.
DO NOT OVERTIGHTEN!
3/8" FLAT
WASHER
3/8" NYLOCK
NUT
6
Copyright © 2017 Aqua Creek Products All Rights Reserved

Revolution Spa Assembly Instructions

1/2" X 2 3/4"
SHOULDER BOLT
5/16" NYLOCK NUT
5/16" FLAT WASHER
ACTUATOR
STEP 2
STEP 3: INSTALL CONTROL ARM
Locate the CONTROL ARM and the following
hardware:
(1) 1/2" x 2-3/4" SHOULDER BOLT
(1) 3/8" FLAT WASHER
(1) 3/8" NYLOCK NUT
Install the CONTROL ARM (end marked "A") onto
the MAST as shown in the fi gure below. Tighten the
NYLOCK NUT until snug as shown in PHOTO 3. DO
NOT OVERTIGHTEN!
3/8" FLAT WASHER
3/8" NYLOCK NUT
3/8" X 2"
SHOULDER
BOLT
LIFTING
ARM
1/2" X 2 3/4"
SHOULDER BOLT
CONTROL
ARM
STEP 3
Revised 12/13/17