AVM EVOLUTION C 5.2 Betriebsanleitung - Seite 7

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Auto-Empfänger AVM EVOLUTION C 5.2 herunter. AVM EVOLUTION C 5.2 15 Seiten.

1.12 Pin configuration of external infrared sensor

Connector for external IR-sensor (23)

3,5mm stereo

infrared input

GND

IR-Signal

+5V supply

In case the C 5.2 was not connected to mains a self test will be performed when it is switched on by

the mains switch (29) for the first time. The unit will check its configuration and that all the installed

components work properly. The procedure is shown in the display. Afterwards the unit will switch to

stand-by.

Using the button power (1) you can switch between on (operate) and stand-by. In the on state the

display (10) lights up and the LED (3) is off. In stand-by mode the display is off and the LED is on to

indicate that the unit is still connected to mains.

CAUTION: When switched to stand-by the unit is still connected to the mains. In case of a

thunderstorm or if you leave the house for a longer time we recommend that you switch the amplifier

off by using the mains switch (29) or pull the mains plug.

The signal source can be selected by turning the source selector (2) until the desired source appears

on the display.

CAUTION: If you switch to another source while playing a CD, the drive will stop first. This may take a

few seconds. If you activate a digital input that has no valid signal, "NO DIG SIGNAL" is indicated in

the display (10). In this case the source can not be changed.

Use the rotary encoder (11) to set the desired volume. Depending on rotating speed the volume

increases / decreases in 0.5 dB steps (slow) or 2 dB steps (fast). The actual setting is shown in the

display (10). If the volume is changed using the RC 3 remote control, the level always increases /

decreases in 0.5 dB steps.

The level of signal sources differs often by several dBs. You recognize a step in volume, when

switching between two different inputs. With the sensitivity setting menu you can avoid this. The

sensitivity of each input can be adjusted between – 9.5 dB and + 10.0 dB.

Select any input (except for tuner or CD) and chose a convenient volume level. Now press the MENU

button (7) under the display for more than 2 seconds. The button is now marked "EXIT LVL". Pressing

this button again will exit the level setting mode and bring the unit back to normal operating mode.