A.J.Antunes 9210820 Handbuch - Seite 12

Blättern Sie online oder laden Sie pdf Handbuch für Toaster A.J.Antunes 9210820 herunter. A.J.Antunes 9210820 20 Seiten. Club toaster

Seite drucken

Club ToasTer CTX-200

Minimum once Yearly:

replacing belt Wraps

Over time, the Belt Wraps will begin to show signs of

wear. This wear appears in the form of tears or discol-

oration of the belt. The Belt Wraps should be replaced

at least once a year.

Note: belt Wraps should be removed oNlY during

belt Wrap replacement or when required in a ser-

vice situation.

reMoVING belt WraPs

1. Turn the Power switch to off. The red light on the

switch turns off.

2. The toaster enters a cool down mode and dis-

plays "oK to Clean." The fans continue to run.

This cool down mode continues for 45 minutes

and shuts the unit down automatically when com-

plete.

Note: You do not need to wait for the count down

to complete. Continue with the cleaning steps as

soon as you see "oK to Clean."

emove the Bun Feeder and Bun Buffer from the

toaster (refer to Figure 1):

4. Press

to stop the Belt Wraps from rotating.

5. Open the Front Cover and Top Cover (Figure 8).

6. Refer to Figure 10. Push up and then drop down

both of the front and rear bottom rollers until they

lock into place. This will remove the tension on

both Belt Wraps.

7. Locate the Connecting Pin on both Belt Wraps

(rotate belts by hand if necessary). Disconnect the

ends of the Belt Wraps by sliding one end of the

Belt off the pin. See Figure 11.

8. Remove both Belt Wraps and discard.

A.J. Antunes & Co.

MaINteNaNCe (continued)

Push both bottom rollers up

and down to lock into place.

this loosens belt Wraps.

figure 10. loosening belt Wraps

figure 11. disconnecting belt Wraps

P/N 1010905 Rev. B 03/12

unhook end of

belt Wrap from

Pins

McDonald's