ABA 2909 Betriebsanleitung

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Schlösser ABA 2909 herunter. ABA 2909 2 Seiten. Retractable

Seite drucken

Parts explanation：

lockset

cassette

Parts name of

◎ Multi-Application: A domestic LCD Television, Laptop, Projector....etc.

◎ Lock slot specification:

（1）

Apply to 7mm x 3mm ~ >7mm x 3.6mm (as drawing to the right)

（2）

An extra lock slot located in a side of lock cassette.

※NOTE: Please make sure the application slot is suitable for above mentioned lock slot specification in case of any damage caused.

◎ Locking steps.

(1)Cable around the immovable article:

Find out a lock hole (if not, find a flat area) -> press the button (1) + pull out the lockset (2). -> Before insert the end of application slot,

the cable should be around the immovable article and cross through the fitting hole of lock cassette (3). (P. 1)

(2)Unlocked modes:

P.2：Push bottom protrudes the lock barrel is un-locked.

P.3：Push bottom stays in the lock barrel is locked.

P.4：If push bottom stays locked, before insert in the end of application slot, you need to:

Holding the lock housing or lock buckle -> holding key handle -> insert key to the end and rotate the key to unlock the lockset-> push

bottom released (lock bottom jump out automatically.) -> Make a left turn -> withdraw key from the lockset-> unlock. (see P.2)

※IMPORTANT: when you try to release the push bottom if your hand do not hold the lock housing or lock buckle, the key will keep

doing idle-running in the lock barrel.

Push bottom protrudes the

lock barrel in the meantime you could

lock anything which is having

7mmx3mm~7mmx3.6mm lock slot.

P.2. Unlocked mode

2909

Retractable Operation Instruction

Lock housing

Push bottom

bottom

Cable

(2)

(1)

Push bottom has been

pushed down, no way to

push in again.

P.3. Locked mode

Covers

Buckle

Connecting

lockset

Parts name of

Notebo

(3)

P.1

Connecting up

Foam

Lock slot

Lock bolt

Immovable article such as table...etc.,

(2) insert key to the

rotate

end and

(1) Holding the

P.4

lock housing or

lock buckle