Avocent LongView Companion Handbuch zur Schnellinstallation - Seite 2
Blättern Sie online oder laden Sie pdf Handbuch zur Schnellinstallation für Extender Avocent LongView Companion herunter. Avocent LongView Companion 8 Seiten.
Auch für Avocent LongView Companion: Merkmale und Vorteile (2 seiten)
Seite drucken
The following instructions will allow you
to set up your LongView extender system.
Should you require further assistance,
please consult your installer/user guide.
1
Place the transmitter at the server
and the receiver next to the
keyboard, monitor and mouse.
2
Connect the transmitter to the
server. Connect the transmitter to
the receiver using a CAT 5 cable.
1
Preparing for installation
Power down the server that will be included in your LongView
extender system. Unplug the peripherals from your server.
Place the LongView transmitter near your server. Place
the LongView receiver near your monitor, keyboard,
mouse, speakers and microphone.
2
Installing the transmitter
Connect a CIFCA cable's 25-pin connector to the INPUT
connector on the rear of the transmitter and the cable's
15-pin video connector to the video output connector
on your server.
If you are using a PS/2 mouse, connect the CIFCA
cable's PS/2 mouse connector into your server's PS/2
mouse port. You may use the transmitter's female serial
COM port if you are using a serial mouse. Use a standard
serial cable (9-pin male to 9-pin female) to connect the
LongView extender serial port to your server's serial
COM port. When using a serial mouse, leave the CIFCA
cable's PS/2 mouse connector unattached.
Check our web site at www.avocent.com/support to search the knowledge base or use the online request.
Avocent, the Avocent logo, The Power of Being There, LongView and Companion are registered trademarks of Avocent Corporation or its affiliates. All other marks are the property of their respective owners. ©2006 Avocent Corporation. All rights reserved.
Quick Installation Guide
LongView
See back for LongView Companion extender installation instructions
To connect a LongView extender
4
Attach the power supply to the power
ports on both the receiver and
transmitter. Power up your system.
Transmitter back
Connect the CIFCA cable's remaining 6-pin connector into
the PS/2 keyboard port on your server.
Connect the speakers and microphone to the appropriate
connectors on the rear of the transmitter.
3
Installing the receiver
Connect a standard CAT 5 Unshielded Twisted Pair (UTP)
cable (up to 500 feet) into the REMOTE I/O port on the
rear of the transmitter. Route the CAT 5 cable to the
receiver's location. Connect the CAT 5 cable to the REMOTE
I/O port on the rear of the receiver.
Connect your monitor, keyboard, mouse, speakers and
microphone to the appropriate connectors on the front
and rear of the receiver. You must use speakers with built-
in amplifiers for proper operation.
4
Powering your system
Connect the circular power plugs into the 24 VDC.5A ports
on the rear of both the transmitter and the receiver.
The Power of Being There
®
Extender
3
Connect the receiver to the
keyboard, monitor and mouse.
Next, connect the power supplies to convenient electrical
outlets. Verify that the power light on the front of both
the transmitter and receiver is lit and not flashing. Power
up your server and monitor.
For additional information
For further instructions on LongView extender hardware
connection, software setup and security configuration,
please refer to the installer/user guide included with
the extender. Visit www.avocent.com for the latest
LongView extender updates.
®
Receiver front
Receiver back