Aqua Medic Turboflotor multi SL Bedienungsanleitungen - Seite 4

Blättern Sie online oder laden Sie pdf Bedienungsanleitungen für Aquarien Aqua Medic Turboflotor multi SL herunter. Aqua Medic Turboflotor multi SL 8 Seiten.

Seite drucken

4. Set-up

The Turboflotor multi SL is a skimmer,

that can be set up in various ways:

1. As an external skimmer, directly mounted on

the aquarium: "Hang on", (fig.3)

2. For use in the cabinet with a

sump or under tank filter system (fig.4)

- next to the filter tank

- in the filter tank

Fig.3: Turboflotor multi SL

in "Hang on" operation

Set up as an external skimmer on the aquarium - Hang on (fig.3)

Assemble the necessary parts of the skimmer, (see fig.1) It now be can be attached to

the aquarium. Look for a protected place within easy reach - at the side or at the back.

The venturi pump (11) is connected with the pressure tube (10). The length of the

flexible tubing (10) should be as short as possible. The pump must be placed directly

below the surface, because the air intake will decrease if it is mounted deeper. A 6-

mm air tube is connected to the air injection nozzle (13) and fixed above the water

level, so the pump can draw in air. Use the full length of the air hose, which is

attached to the silencer (15).

We recommend securing the hose with the clips provided. Now the skimmer can be

aligned with the aquarium. The two screws at the bottom of the skimmer are adjusted

in such a way that the skimmer is hanging safely on the aquarium. It is advantageous

if the skimmer is not 100% upright, but leaning slightly (5º) to the aquarium (Fig.3).

The skimmer is then not only hanging more safely, but also back-flow of water from

the outflow box over the aquarium frame is prevented. Both adjusting screws at the

bottom are supplied with silicone suction cups for increased safety.