CP EBDHS-DD-LT30 Produkthandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Produkthandbuch für Sicherheitssensoren CP EBDHS-DD-LT30 herunter. CP EBDHS-DD-LT30 13 Seiten. Ceiling pir hs presence detector–dali/dsi, low temperature

Seite drucken

Assembly

The EBDHS-DD-LT30

may be supplied in two

parts. Follow the

instructions to

assemble.

The EBDHS-DD-LT30 is designed to be mounted using either:



Flush fixing, or



Surface fixing, using the optional Surface Mounting Box (part no. DBB).

Both methods are illustrated below.

Use the supplied gasket to ensure IP rating (not compatible with Surface Mounting Box part no. DBB).

Flush Fixing

Warning - be careful

bending springs when

mounting unit.

Surface Fixing

Wire stripping details

Overview

It is a requirement of many fluorescent lamp manufacturers to have the lamps on at maximum output for a period of time

to guarantee lamp life (refer to the manufacturer's datasheet for details) As this EBDHS-DD-LT30 is able to dim the

lamps using DALI/DSI, the product provides a facility to disable this for a given period of time.

Operation

By setting the "Burn in" parameter, you can select a time during which the lamps are not allowed to deviate from

maximum output. The unit counts the time, and even remembers how long has elapsed in the event of a power failure.

To cancel the burn in function, simply select a time of 0. Note that when the lamps are changed, the burn in time should

be set again.

Push-in sensor

head connector to

mating socket on

power supply unit.

Locate sensor head

onto power supply

and clockwise rotate

until locked.

Remove connector

cover

Hole Ø64mm

50mm or 60mm fixing centres

Pull out spring tab and rotate

spring arm as shown

Installation

Important

Ensure that the cables are formed as shown

before affixing the cable clamp. The clamp

MUST clamp the outer sheath(s) only.

Bend cores as shown.

Burn-in