CP Electronics EBMHS series Produkthandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Produkthandbuch für Sicherheitssensoren CP Electronics EBMHS series herunter. CP Electronics EBMHS series 12 Seiten. Miniature hs pir presence detector (standalone)

Seite drucken
The product is designed to be mounted directly to a luminaire, either on the inside or outside. The detector should be
sited so that the occupants of the room fall inside the detection pattern (shown opposite), at a recommended ceiling
height of 2.8m. Note that the lower the sensor is installed the smaller the detection range will be, subject to the
parameters shown on the detection diagram.
For optimum operation of the lux sensor, the lens must shielded as much as possible from the light source.
If flush mounting in a panel >6mm thick, remove bottom of retention arms with side cutters.
Avoid direct sunlight entering the sensor.
Do not site within 1m of forced air heating or ventilation.
Do not fix to a vibrating surface.
Detection mode
Presence When movement is detected the load will automatically turn on. When the area is no longer occupied the
load will automatically switch off after an adjustable time period.
Absence The load is manually switched on. When the area is no longer occupied the load will automatically switch
off after the adjustable time period has elapsed.
Switch operation:
PRM single switch: short press turn on, long press turn off.
In either case, sensitivity to movement of the PIR sensor can be adjusted using the Sensitivity parameter.
Switch Level On/Off
Occupancy detection can be made dependant on the ambient light level using the Lux On Level and Lux Off Level
parameters.

Installation

Sensor functionality

3