CP Electronics MWS3 Produktdaten und Installationsblatt - Seite 2

Blättern Sie online oder laden Sie pdf Produktdaten und Installationsblatt für Sicherheitssensoren CP Electronics MWS3 herunter. CP Electronics MWS3 2 Seiten. Multi-sense microwave presence detector

Seite drucken

ETECTION

ATTERNS

IMPORTANT NOTICE!

This device should be installed by a qualified electrician

in accordance with the latest edition of the IEE wiring

regulations.

IDEAL FOR CORRIDOR

OR AISLE APPLICATIONS

IDEAL FOR CORRIDOR

OR AISLE APPLICATIONS

IDEAL FOR OPEN PLAN

AREAS AND OFFICES

Due to our policy of continual

p r o d u c t

Electronics reserves the right to

alter

product without prior notice.

AULT

INDING

LOAD DOES NOT COME ON

Check to see if the live supply to the circuit is good. Strap across the L

and LIVE OUT terminal to turn the load on.

If the supply and wiring are good, check the LUX level setting. In-

crease the LUX level setting to allow the controller to turn on at higher

ambient natural light level.

LIGHTS DO NOT GO OFF

Ensure that the area is left unoccupied for a greater time period than

the time out period set using the switch.

Make sure that the sensor is not adjacent to vibrating surfaces or

objects (e.g. ventilation equipment).

The unit may pick up movement through thin partitions or walls. Re-

duce the sensitivity by turning the adjuster anticlockwise.

The unit may pick up movement that occurs behind the sensor. Re-

duce the sensitivity by turning the adjuster anticlockwise.

PECIFICATION

LOAD

10 Amp resistive load

8 Amp incandescent lighting

5 Amp fluorescent lighting

3 Amp compact fluorescent lighting

3 Amp low energy lighting

3 Amp low voltage lighting (switch primary of transformer)

Fluorescent lighting (max 6 fittings recommended)

For fluorescent lighting total power factor correction capacitance must

not exceed 40 F.

3 Amp fans and ventilation equipment

Switch SON lighting loads via a contactor

SUPPLY VOLTAGE

TIME OUT PERIOD

LIGHT LEVEL

FIXING METHOD

TERMINAL CAPACITY 1.5 mm

MATERIAL

TYPE

TEMPERATURE

SAFETY

CONFORMITY

ART

UMBERS

MWS3

Multi-sense microwave presence detector

C.P. Electronics Ltd

Unit 2 Abbey Manufacturing Estate

Mount Pleasant, Wembley

Middlesex. HA0 1RR

Tel:

i m p r o v e m e n t

C P

Fax:

the

specification

this

www.cpelectronics.co.uk

[email protected]

220-240 Volts AC 50 Hz

Adjustable 15 seconds to 30 minutes.

Light to dark.

Flush fixing in 86mm hole using clip provided

Surface fixing using integral back plate

Flame retardant ABS, fixing clip polypropylene

Class 2

-10° C to 35° C

The microwave radiation emitted by these units

is exteremely low power.

At a distance of > 50mm the power density is

<6% of the ANSI IEEE C95.1 –1991 recom-

mended microwave power density.

At a distance of 5mm from the unit it is <84%

of recommended power density.

EMC-89/336/EEC

LVD-73/23/EEC

+ 44 (0) 20 8900 0671

+ 44 (0) 20 8900 0674

Ref %WD136 Issue 1