AVOURY ONE Benutzerhandbuch - Seite 16
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Küchengeräte AVOURY ONE herunter. AVOURY ONE 20 Seiten.
Auch für AVOURY ONE: Benutzerhandbuch (20 seiten), Kurzanleitung (10 seiten), Kurzanleitung (3 seiten)
Seite drucken
C L E A N I N G A N D D E S C A L I N G
Descaling
When the LED "Carry out descaling"
a continuous light the descaling programme
should be started. The programme takes approx.
15 minutes.
Important: Remove the water filter before
descaling!
1.
Switch on the tea machine and wait until the
Start- Button
shows a continuous light.
2. Activate the care mode.
3. Open the capsule compartment
insert an empty descaling capsule (no lid foil
needs to be removed). Then close the capsu-
le compartment
2
4. The LED "Carry out descaling"
flash red and the Start-Button
continuous light.
The LED "Carry out descaling"
red throughout the whole descaling
programme and goes off when the
programme is finished.
5. To start the descaling programme, press the
Start-Button
.
6. The LEDs "Empty water tank"
capsule container"
red light.
7. Empty the water tank
filter, please remove it.
8. Fill the water tank
tents of the Avoury liquid descaler (250 ml)
and an additional 250 ml of fresh tap water.
9. Reinsert the water tank
10. The LED "Empty water tank"
shows
and
2
.
starts to
shows a
flashes
and "Empty
show a continuous
. If you use a water
4
with the entire con-
4
.
4
goes off.
11. Remove the drip drawer
drip tray and the capsule container.
12. Put everything back in place and place a
heat-resistant collecting vessel with a
capacity of at least 300 ml under the outlet
.
8
Caution: The liquid is very hot!
13. The LED "Empty capsule container"
off and descaling begins automatically.
Descaling is carried out in two cycles. The
descaling liquid that has run through the
machine flows into the collecting vessel.
First cycle
14. The first cycle is finished when the Start-
Button
shows a continuous light.
15. Empty the collecting vessel then put it back
under the outlet
8
Second cycle
16. Press the Start-Button
descaling cycle.
17. The second cycle is finished when the LEDs
"Empty water tank"
container"
show a continuous light and
the Start-Button
18. Remove the water tank
remaining liquid.
19. Rinse the water tank
water.
20. If required, put the water filter back into the
water tank
.
4
21. Fill the water tank
fresh tap water and put it back in place. The
LED "Empty water tank"
to empty the
7
goes
.
to start the second
and "Empty capsule
flashes.
and pour out any
4
with fresh tap
4
completely with
4
goes off.
EN
PAGE 37