ABACUS Aquanova Scorpio 1700 Information Pack - Seite 10
Blättern Sie online oder laden Sie pdf Information Pack für Badewannen ABACUS Aquanova Scorpio 1700 herunter. ABACUS Aquanova Scorpio 1700 18 Seiten. Fixed seat & transfer system
Seite drucken
Scorpio 1700 Installation Instructions
Tap & Waste Connection
Connect the taps using the flexible water pipes provided making sure they do not snag when the bath
is lifted. Trimming of the inner lower & outer upper panels may be required to fit the panels around
the pipe. The waste is pre-assembled. Connect the flexible pipe to the waste outlet. Fit the manifold to
the floor and connect as detailed.
Electrical Connection
The control unit is located in the centre of the underside of
the bath. A prewired lead is supplied and this should be run to
the mains supply as per the pre-install connections. The
handset should be plugged in the control box as per FIG 3.
Ensure the lead retaining clip is refitted once the
handset has been connected.
Panel Fixing
The bath shell comes complete with the outer
upper panels fitted. These should fit outside the
inner lower panels and should not touch them.
Note: if the upper and lower panels touch, marking
will occur. Adjustment is possible on the bayonet clip if required.
Inner Panel Fitting
Offer the corner inner end panels (right and left) up to the bath and secure using the
M4 x 12mm white plastic topped machine screws supplied (Fig. a) Screw through
holes in panels and into the rivnuts positioned in the frame uprights. Also use plastic
topped srews to secure to corner panels together.
Use the white plastic dome nut fixings (Fig. b) to secue the centre cosmetic inner panel to the corner
panels. These nuts fit to threaded studs bonded to each corner panel. Use a quantity of 2 to connect
the inner centre panel to the right corner panel and 2 to connect to the left corner panel.
Sliding Panels
Take the two sliding panel assemblies and o er them under either end of the bath & fasten them in
place using the L brackets. Note that the white cross-bracket (c) onto which they t is secured to the
bath frame via slots, allowing some sideways adjustment. This adjustment should be used to ensure
that the sliding panels do not catch on the rigid foot skirts as they rise and fall.
Tip - Make sure they are the correct side up so that they fully extend. They will not reach the oor.
(c)
Plumbing Manifold
a.
b.
10