Abacus Electric Evolve Sonix Benutzerhandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Sicherheitssystem Abacus Electric Evolve Sonix herunter. Abacus Electric Evolve Sonix 10 Seiten. Wireless gsm alarm

Seite drucken

Wireless PIR detector

- Power supply: DC9V (inner 9V battery)

- Static current: ≤100 mA

- Transmission current: ≤20 mA

- Transmission frequency: 315/433 ± 0,5 MHz

- Wireless coverage: in open space 80 m

- Detection speed: 0,3 – 3 m/s

- Detection distance: 5 ~ 12m

- Detection coverage: horizontally 110°, vertically 60°

Troubleshooting:

Signs

The alarm cannot be

activated by the phone

It is necessary to use the

remote control from near

and the warning light shines

too weakly

The warning of the door

sensor and PIR shines

permanently

Dialling is slow

The main drive doesn´t

receive the signals from the

sensors

Do not place the alarm near the devices that might emit strong electromagnetic interference (e. g. motors,

computers, and so on). Put the alarm main drive to the hidden place. The main drive must have all the cables

tightly connected and mustn´t be covered – because of the easy heat supply. Sonix is made for the inner use only

2200 DECLARATION OF CONFORMITY:

Hereby, the company ABACUS Electric s. r. o. declares that this model EVOLVE Sonix is in compliance with the

requirements of the norms and regulations, relevant for the given type of device. The complete text of

Declaration of conformity can be found at ftp://ftp.evolve-europe.com/ce/.

EVOLVE support: the files for downloading, settings, manuals and other information relating to the EVOLVE

products can be found at

Reasons

1. The alarm wasn´t turned on

2. It hasn´t been on long enough

– at least 30 seconds

3. The wrong number was set

4. Counterparts of the

window/door sensors were

installed too far from each

other

5. The PIR sensor wasn´t

activated

6. The code wasn´t checked

1. The battery in the remote

control is rusted

2. The battery is low

The battery is low

The main drive has saved

different numbers

The code wasn´t checked

www.evolve-europe.com

- Operation conditions: temperature –10°C ~ + 40°C

/ humidity ≤ 90% rh

Remote control

- Power supply: DC12V (inner 12V battery)

- Transmission current: ≤15mA

- Transmission frequency: 315/433 ± 0,5 MHz

- Wirelesscoverage: in open space 80 m

Solving

1. Turn on the alarm

2. Activate it 30 seconds after turning on

3. Set the number again and exactly according

to the instructions

4. Set placing of the sensors' counterparts

5. Activate PIR

6. Check the code

1. Remove the rust

2. Change the battery

Change the battery

Set the numbers again and exactly according

to the instructions

Check the code