Aqua Quip QC Series Installationsanleitung und Benutzerhandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Installationsanleitung und Benutzerhandbuch für Schwimmbad-Beleuchtung Aqua Quip QC Series herunter. Aqua Quip QC Series 4 Seiten. Surface-mounted led retro-fit pool light
Auch für Aqua Quip QC Series: Installationsanleitung und Benutzerhandbuch (4 seiten)
Seite drucken
INCLUDED WITH THE QC SERIES LED POOL LIGHT FOR CONCRETE POOLS:
1
TOP
Item Description
1
Universal Mounting Bracket
2
Mounting Screws x 3
3
LED Light Only
INSTALLATION INSTRUCTIONS
1) A rigid PVC conduit (min. 20mm diameter) should be run from the pool wall back to the plant room, where the
transformer will be located. The conduit should be installed as to prevent water siphoning from the pool. The
location of the pool light should be in such a position to allow enough cable to be wound up at the rear of the light
to enable it to be floated to the pool deck. A location should also be chosen that minimises any shadowing from
the light beam.
2) The Universal Mounting Bracket can be rendered to the pool wall or screwed directly on top of the pool interior,
either way ensure the bracket is oriented correctly. The word "TOP" is moulded into the bracket.
Marking Line
Diagram 1
3) The Cable can be fed through at a convenient time throughout the construction, it is factory-fitted with a protective
Cable Cap to protect the electrical connector and O-rings from moisture, dust and grit. As mentioned above, ensure
enough cable is left for future servicing.
4) When the pool is ready to be filled, then the Quick Connect Plug Kit is now ready to be inserted into the receptacle
on the rear of the QC Series Led Pool Light. Unscrew and save the three screws that are securing the Cable Cap to
the Cable Bracket. Remove the Cable Cap by disengaging the two clips on the Cable Bracket. The two O-rings are
factory-lubricated, ensure they are free from dust and grit. Align the Quick Connect Plug Kit with the exposed metal
pins in the receptacle on the rear of the QC Series LED Pool Light
and push into place. Push the Cable Bracket towards the light until
the clips engage into place. Use a #1 Phillips screwdriver and three
screws (saved from above) and secure the Cable Bracket into the
three screw holes. Do not overtighten. See Diagram 2.
5) Wind up excess cable around the hooks on the rear of the QC Series
LED Pool Light. Use the three PE6 screws provided to mount the
QC Series LED Pool Light onto the three posts on the Universal
Mounting Bracket.
2
QC SERIES SURFACE MOUNTED LED LIGHTS FOR CONCRETE POOLS – INSTALLATION INSTRUCTIONS & OWNERS MANUAL
QC SERIES
2
Item Description
4
Cable, assembled with Quick Connect Plug
5
Cable Cap
6
Quick Connect Plug
When pebblecreting, plastering or rendering: Cover the circular frame of the
Mounting Bracket with the finished pool surface up to the marking line on the three
mounting posts. After the pool surface has been applied, only the 3 mounting posts
will be visible.
When screwing directly onto pool wall: Drill 4 holes in pool wall, aligning with the
four screw hole provisions marked in RED in Diagram 1. Use the APL071 Retro-Fit
Screw Kit (see page 3, item 7) available for purchase as an optional extra.
Note: Trim Back the three mounting posts by 5mm, which will then enable the rear of
the clear lens to sit against the interior pool surface.
SURFACE MOUNTED LED
LIGHTS for CONCRETE POOLS
3
4
6
5
Additional parts
diagram is shown
on Page 3.
Diagram 2