Allied Telesis AT-9816GB Handbuch zur Schnellinstallation - Seite 7
Blättern Sie online oder laden Sie pdf Handbuch zur Schnellinstallation für Schalter Allied Telesis AT-9816GB herunter. Allied Telesis AT-9816GB 12 Seiten. At-9800 series
Auch für Allied Telesis AT-9816GB: Handbuch zur Schnellinstallation (11 seiten)
Seite drucken
Quick Install Guide
C613-04038-01 REV F
10. Connect the Redundant Power Supply (Optional)
AC models of AT-9800 Series switches have a Redundant Power Supply
(RPS) connector on their rear panel.
AT-9812TF and AT-9816GF AC models can be used with AT-RPS8000 RPS
systems, while AT-9812T and AT-9816GB AC models can be used with
AT-RPS9000 systems.
RPS systems can be purchased separately, contact your authorised Allied
Telesyn distributor or reseller for more information.
11. Install GBICs
Any combination of copper and fibre GBICs can be installed in the
following AT-9800 Series switches:
•
AT-9812T
•
AT-9812TF
•
AT-9816GB
For the AT-9816GF, up to fourteen 1000BASE-T GBICs can be installed. The
actual number depends on the number of fibre GBICs also installed.
Table 1 on page -7 lists the number of 1000BASE-T GBICs that can be
installed in the AT-9816GF for various copper/fibre combinations.
Table 1: GBIC configurations for the AT-9816GF.
Number of fibre GBICs installed
0
1
2
3
4 or 5
6
7
8
10 or 11
12
13
14
15
16
Slide the GBICs into the GBIC slots. Press each GBIC firmly into place.
A range of GBICs have been tested and approved for use with AT-9800 Series switches,
contact your authorised Allied Telesyn distributor or reseller for more information, or
visit www.alliedtelesyn.co.nz/support/at9800.
RX and TX terminal locations on SC fibre GBIC ports are the reverse of RX and TX
terminal locations on fixed SC fibre ports. When looking at an SC fibre GBIC from the
front, the RX terminal is on the left and the TX terminal is on the right.
Maximum number of 1000BASE-T GBICs that
can be installed
14
13
12
11
10
9
8
7
5
4
3
2
1
0
7