AVS Ventvisor Installationsanleitung Handbuch - Seite 2

Installation Steps

Remove tape liner from rear flange of visor. Peel back 2" (5 cm)

of tape liner from each end of the lateral flange.

free end

lateral flange

rear

flange

Gently press the exposed areas of tape against the surface and verify position. With the visor in its final position, remove the remaining

tape

PRESS

visor

cross section of visor in

place

Apply pressure along all flanges to ensure proper adhesion of tape.

4 Piece Set

NOTE: Actual application may vary slightly from illustrations.

free end

front

flange

tape liner by pulling on free ends.

metal window frame

rubber window channel

The rear visor attaches with the same preparation methods as the front visor.

Repeat Steps 1-8 for opposite side.

Align visor to the previously cleaned surface. The lateral flange will

attach to the black metal door frame. Insert the front end flange

between the mirror cap and the front door.

Retighten previously lossened screws, and replace plastic mirror

Page 2 of 3

cap