Abarqs IBF-30 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kühlboxen Abarqs IBF-30 herunter. Abarqs IBF-30 18 Seiten.

USER MANUAL EN, PL,

Getting Started

Installation

After unpacking the Fridge/Freezer check that no parts are missing. Place the unit in a dry place

which is protected against splashing water. Do not place directly adjacent to sources of heat such

as heating, gas ovens, hot-water , pipes or under the blazing sun.

It is important that your appliance is installed and operated in accordance with these instructions

to guarantee its performance, efficiency and operation.

Application and operative cooling range

The cooling compartment has varying temperature zones. The values indicated on the digital

display are related to the middle of the cabinet. Your Fridge/Freezer is designed to either

refrigerate or freeze food. The Fridge/Freezer may be used for outdoor use such as for camping

purposes. If you wish to refrigerate medicines, first check to ensure the Fridge/Freezer's cooling

capacity meets the demands of the respective medicines. The Fridge/Freezer is designed to

operate in ambient temperature between -20℃ and +20℃ in a maximum air humidity of 90%.

Note:

1. The normal operation of the appliance requires heat to be radiated away from the condenser

located in rear of the cabinet. Adequate airflow is required around the compressor at all times.

2. The cooling system has been designed to operate correctly when the appliance is positioned

and angles up to 30 degrees. It is recommended that the time the unit is exposed to angles over

30 degrees is limited to a maximum of 4 hours continuous operation.

3. Your appliance can be used as either a freezer or a refrigerator; it cannot be used as both

simultaneously.

Power Requirements

The Fridge/Freezer is designed to opearte on DC voltage.

DC input 12V or 24V DC(e.g. car cigarette lighter or car battery)

AC connect with adaptor 220-240V

General

If the Fridge/Freezer is operating when the vehicle ignition is switched OFF, the Fridge/Freezer

will switch OFF automatically when the power source voltage falls below the Battery Monitor

cut-out setting.

The Fridge/Freezer will automatically switch back ON when the vehicle is re-started.

DC Connection

Plug the 12V/24V DC power cable into the DC POWER socket at the rear of the Fridge/Freezer and

then connect to the vehicle cigarette lighter socket or suitable 12V or 24V DC power source.

Select the power switch button to turn the Fridge/Freezer ON.

The display will automatically show the current internal cabinet temperature.

For optimum performance and efficiency, it is important that the Fridge/Freezer has a reliable DC

power source available. Direct connection to the battery is recommended and reduces the risk of

voltage dropping to the appliance.

5 |

S t r o n a