CPG 351FGC100DDN Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Backofen CPG 351FGC100DDN herunter. CPG 351FGC100DDN 12 Seiten. Gas powered convection ovens
Auch für CPG 351FGC100DDN: Service-Handbuch (18 seiten)

Seite drucken

User Manual

351FGC100DD(L/N) | 351FGC20DD(L/N)K

Startup

Installation

1 . Remove packaging before beginning installation .

NOTE:

Some parts are protected with an adhesive film. Remove any glue residue with approved substances,

such as Noble Chemical Strike All Purpose Cleaner (#147STRIKE1G); never use abrasive substances . (See

Cleaning & Maintenance on pg . 12 for our other recommended cleaning agents and further cleaning instructions)

2 . Mount the feet and adjust the height by loosening or tightening each foot to ensure the unit is level .

3 . The gas/electrical connections must be close to the equipment and easy to reach . You must use a new gas hose

to connect to this unit .

4 . Place the unit under an exhaust hood, ensuring you comply with your local regulations.

5 . Install the unit at least 2" from the wall and at least 6" from other heat-producing equipment. Any wall, surface,

cabinet, table, etc. in close proximity to the equipment should be made of non-combustible materials with proper

thermal insulation .

6 . Law provisions, technical regulations, and directives:

The manufacturer requires the installation to be performed according to national and local codes and must be

performed by a licensed installer .

7 .

Turn on the electric and gas valves:

a . Manually remove the wing nut located above the control panel (Fig . 1) and carefully open

the control panel . (Fig . 2)

b. Remove the screws on the back of the oven, then open the right side panel. (Fig. 3)

c . Check to ensure that the electric and manual intake valves are open . (Fig . 4)

d. Reinstall the right panel, then reattach the control panel with the wing nut.

NOTE:

For complete shutdown follow these instructions, but instead close the electric and manual intake valves.

Fig. 1

8 . Checking the functions:

Start the appliance; check the gas pipes for leaks; check the burner flame. See Gas Connection section on page 7

for more details .

Notes for the Installer

•

Explain and demonstrate to the user how the equipment works according to the instructions, and

ensure that the user manual is accessible .

•

Remind the user that any structural alterations or modifications made to the room that houses the

equipment will warrant a recheck of the equipment functions .

•

Do not install the equipment close to other units that can reach high temperature, as the electrical

components could be damaged. A 6" minimum clearance is required from such equipment.

Fig. 2

Fig. 3

Fig. 4