CPG CBL48 Anweisungen für Installation und Betrieb - Seite 6

Blättern Sie online oder laden Sie pdf Anweisungen für Installation und Betrieb für Broiler CPG CBL48 herunter. CPG CBL48 16 Seiten.

LIGHTING INSTRUCTIONS

The pilot light on the appliance has been set at the factory. A screwdriver may be required for the

first lighting to adjust the flame for your elevation.

1. Turn off the manual valve and wait 5 minutes to clear the air gas.

2. Turn all knobs to the "OFF" position.

3. Hold an ignition source (match) at the pilot. When the flame is established, remove the

ignition source.

4. Turn the burner knobs to "ON". If the burner does not ignite, promptly open the pilot valve

more. If the pilot flame appears larger than necessary, turn it down and reset burner ignition. The

pilot flame should be as small as possible but large enough to guarantee reliable ignition of the

burners when the knobs are turned to "ON".

Lighting main burner

To light burner, turn knob to "ON." Then adjust to the desired flame level. The range of adjustment

is virtually infinite between "ON" and "OFF".

Main burner air supply:

1. For efficient burner operation, a proper balance of gas volume and primary air supply must be

maintained which will result in complete combustion. Insufficient air supply results in a yellow

streaming flame. Primary air supply is controlled by an air shutter on the front of the burner.

2. Loosen the screws on the front of the burner and adjust the air shutter to just eliminate the

yellow tips of the burner flame. Lock the air shutter in place by tightening the screws.

CAUTION

Never attempt to move a grill section while cooking. An unexpected flare could cause severe injury.

Turn off the unit, let it cool and use potholders and/or gloves to reposition or remove. The space

between the legs at the bottom admits combustion air. DO NOT BLOCK THIS SPACE.

All burners are lit from constantly burning pilots. Turning the valve to the desired flame height is

all that is required to put the unit in service.

Do not permit fans to blow directly at the unit. Wherever possible, avoid open windows next to

the units' sides or back. Avoid wall type fans which create air cross-currents within a room.

It is also necessary that sufficient air should be allowed to enter the room to compensate for the

amount of air removed by any ventilating system. Otherwise, a subnormal atmospheric pressure

will occur, affecting operation and causing undesirable working conditions.

A properly designed and installed hood will act as the heart of the ventilating system for the room

or area in which the unit is installed, and will leave the unit independent of changing draft

conditions.

All valves must be checked and lubricated periodically. This must be done by an authorized service

representative in your area.