CPI 1.2M Ku-BAND Series Montageanleitung - Seite 14

Blättern Sie online oder laden Sie pdf Montageanleitung für Antenna CPI 1.2M Ku-BAND Series herunter. CPI 1.2M Ku-BAND Series 15 Seiten.

CPI Satcom & Antenna Technologies

STEP 3:

Fine Azimuth Adjustment:

adjustments in azimuth can be made by loosening the three Locking Hex

Nuts on the underside of the Canister top plate of the Az/el Positioner

and the two hex nuts under the Azimuth Pivot Posts.

With this hardware loosened, adjustments in azimuth can be made by

turning the Azimuth Adjust Bolt at the back of the Az/El Positioner in either

direction. See Figure 3-3.

Note: Azimuth Adjust Rod is for adjustment only, it is not intended to

be part of the structural integrity of the assembly, therefore

"tightening" the Azimuth Adjust Bolt is not necessary.

Azimuth Adjust Bolt

Azimuth Pivot Post

Hex Nuts

(2 Places)

Locking Hex Nuts

(3 Places)

STEP 4:

Peak the antenna signal by fine adjustments made in both Azimuth and

Elevation until the optimum signal is achieved.

STEP 5:

Securely tighten all hardware used for adjustment.

Once the target satellite is located, fine

Figure 3-3

1.2M Ku-BAND SERIES 1122

4096-1000