Dell 1737 - Studio - Laptop Service-Handbuch - Seite 31
Blättern Sie online oder laden Sie pdf Service-Handbuch für Laptop Dell 1737 - Studio - Laptop herunter. Dell 1737 - Studio - Laptop 48 Seiten.
Seite drucken
Back to Contents Page
Memory
Dell™ Studio 1735/1737 Service Manual
Removing the Memory Module(s)
Replacing the Memory Module(s)
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your Quick Reference Guide for information
on the memory supported by your computer. Install only memory modules that are intended for your computer.
NOTE:
Memory modules purchased from Dell are covered under your computer warranty.
Your computer has two user-accessible SODIMM sockets that can be accessed from the bottom of the computer. The DIMM B memory module is located directly
above the DIMM A memory module located on the bottom of the computer.
NOTICE:
If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMM A" before you install
a module in the connector labeled "DIMM B."
Removing the Memory Module(s)
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as a connector on the back of the computer).
1. Follow the procedures in
Before You
2. Turn the computer over and remove the base cover (see
1
DIMM B memory module
NOTICE:
To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.
3. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
4. Remove the module from the connector.
Begin.
Removing the Base
2
DIMM A memory module
Cover).