Dell Alienware M11x Service-Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Service-Handbuch für Laptop Dell Alienware M11x herunter. Dell Alienware M11x 40 Seiten. Service manual

Seite drucken
Back to Contents Page
  Before You Begin
Alienware® M11x Service Manual
  Recommended Tools
  Turning Off Your Computer
  Before Working Inside Your Computer
This manual provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that the
following conditions exist:
 You have performed the steps in
l
 You have read the safety information that shipped with your computer.
l
 A component can be replaced or—if purchased separately—installed by performing the removal procedure in reverse order.
l
 Recommended Tools
The procedures in this document may require the following tools:
 Small flat-blade screwdriver
l
 Phillips screwdriver
l
 Plastic scribe
l
 BIOS executable update program at support.dell.com
l
 Turning Off Your Computer
 
CAUTION:
To avoid losing data, save and close all open files and exit all open programs before you turn off your computer.
 
1. Save and close all open files and exit all open programs.
 
2. Click Start
, click the arrow
The computer turns off after the operating system shutdown process finishes.
 
3. Ensure that the computer and any attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut
down your operating system, press and hold the power button for at least 8 to 10 seconds until the computer turns off.
 Before Working Inside Your Computer
Use the following safety guidelines to help protect your computer from potential damage and to help to ensure your own personal safety.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
 
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
 
CAUTION:
Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal
mounting bracket. Hold a component such as a processor by its edges, not by its pins.
 
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ 
is not covered by your warranty.
 
CAUTION:
When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have connectors with locking
tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep
them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented
and aligned.
 
CAUTION:
To avoid damaging the computer, perform the following steps before you begin working inside the computer.
 
1. Ensure that the work surface is flat and clean to prevent the computer cover from being scratched.
 

Turning Off Your Computer

and
Before Working Inside Your
, and then click Shut Down.
Computer.