Dell C600 - Latitude Intel P-4 1.4GHz Service-Handbuch - Seite 23
Blättern Sie online oder laden Sie pdf Service-Handbuch für Laptop Dell C600 - Latitude Intel P-4 1.4GHz herunter. Dell C600 - Latitude Intel P-4 1.4GHz 46 Seiten. Latitude c600/c500 series
Auch für Dell C600 - Latitude Intel P-4 1.4GHz: Service-Handbuch (48 seiten)
Seite drucken
Removing and Replacing Parts : Dell Latitude C600/C500 Series Service Manual
1. Remove the
hard
2. Remove the
display
3. Use the scribe to pry the six rubber screw covers out of the screw holes located on the bezel on the front of the
display assembly.
4. Remove the six M2.5 x 5-mm screws located on the bezel on the front of the display assembly.
NOTICE:
To avoid damage to the bezel, do not bend the bezel while separating it from the display-assembly top
cover.
5. Use a plastic scribe to carefully separate the bezel from the
display-assembly top cover.
Removing the 14.1-Inch Display Panel
NOTICE:
Disconnect the computer and any attached devices from electrical outlets, and remove any installed
batteries.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface
on the computer.
1. Remove the
hard
2. Remove the
display
3. Remove the
display assembly
4. Remove the
hinge
5. Remove the two M2 x 4-mm screws on the left side of the
side of the
display
NOTE:
If you have a Hitachi display panel, remove the two M2 x 4-mm screws from the center of the left side of the
display panel.
6. Remove the M2 x 4-mm screw that secures the display-feed flex cable to the display assembly through the black
plastic flex cable retention bracket (see
7. Disconnect the bottom flex cable connector from the display-assembly top cover and inverter connector by pulling
straight up on the attached pull tab.
8. Lift and rotate the top of the display panel out of the display-assembly top cover.
Replacing the 14.1-Inch Display Panel
1. Place the bottom edge of the display panel in the bottom of the display-assembly top cover and elevate the top of the
panel with your hand.
2. Place the display panel in the display-assembly top cover.
3. Reinstall the five M2 x 4-mm screws that secure the display panel to the display-assembly top cover.
Removing the Display-Feed Flex Cable (14.1-Inch Display Panel)
Display-Feed Flex Cable
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/L...600/C500%20C600%20Service%20Manual/remove.htm (14 of 36)6/21/2004 1:22:14 AM
drive.
assembly.
drive.
assembly.
bezel.
covers.
panel.
"14.1-Inch Display Assembly Bezel and
display panel
and the two M2 x 4-mm screws on the right
Panel").