Dell Inspiron 1210 Service-Handbuch - Seite 35

Blättern Sie online oder laden Sie pdf Service-Handbuch für Laptop Dell Inspiron 1210 herunter. Dell Inspiron 1210 39 Seiten. Service manual
Auch für Dell Inspiron 1210: Schnellstart-Handbuch (19 seiten)

Seite drucken
Dell Inspiron 1210 Service-Handbuch
Back to Contents Page
  Replacing the System Board
Dell™ Inspiron™ 1210 Service Manual 
  Entering the Service Tag in the BIOS
  Setting the Keyboard Matrix
 
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTE:
The system board's BIOS chip contains the service tag, which is also visible on a barcode label at the bottom of the computer.
 
1. Follow the instructions in
Before You
 
2. Remove the palm rest. See
 
3. Disconnect the display cable from its system board connector. See
1
power cable
3
CRT cable
5
2-in-1 camera connector
7
hard disk cable
 
4. Disconnect power cable from the respective system board connector. See
 
5. Disconnect CRT cable from the respective system board connector. See
 
6. Disconnect USB cable from the respective system board connector. See
 
7. Disconnect coin-cell battery cable from the respective system board connector. See
 
8. Disconnect hard drive cable from the respective system board connector. See
 
9. Remove the two screws that secure the system board to the computer base.
 
10. Lift the system board at an angle towards the side of the computer and out of the computer base.
 
11. To replace the System Board, follow all of the steps in
NOTICE:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in
damage to the computer.
 
12. Turn on the computer.
NOTE:
After you have replaced the system board, enter the computer Service Tag into the BIOS of the replacement system board.
Begin.
Replacing the Palm
Rest.
2
2-in-1 cable: LVDS connector
4
USB cable
6
coin-cell battery cable
 
 

Replacing the System Board

Replacing the
Display.
Replacing the Power
Cable.
Replacing the CRT
Board.
Replacing the USB
Board.
Replacing the Coin-Cell
Replacing the Hard
Drive.
in reverse order.
Battery.