Dell Inspiron Mini 9 910 Service-Handbuch - Seite 34

Blättern Sie online oder laden Sie pdf Service-Handbuch für Laptop Dell Inspiron Mini 9 910 herunter. Dell Inspiron Mini 9 910 39 Seiten.

Back to Contents Page

Solid-state Drive

Dell™ Inspiron™ 910 Service Manual

Removing the Solid-state Drive

Replacing the Solid-state Drive

CAUTION:

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

CAUTION:

If you remove the solid-state drive from the computer when the drive is hot, do not touch the solid-state drive.

NOTICE:

To prevent data loss, turn off your computer (see

state drive while the computer is on or in Sleep state.

NOTICE:

Solid-state drives are extremely fragile. Exercise care when handling the solid-state drive.

NOTE:

Dell does not guarantee compatibility or provide support for solid-state drives from sources other than Dell.

NOTE:

If you are installing a solid-state drive from a source other than Dell, you need to install an operating system, drivers, and utilities on the new

solid-state drive (see related topics in your Setup Guide).

Removing the Solid-state Drive

1. Follow the instructions in

Before You

2. Remove the module cover (see

NOTICE:

When the solid-state drive is not in the computer, store it in protective antistatic packaging (see "Protecting Against Electrostatic Discharge" in

the safety instructions that shipped with your computer).

screw (2)

3. Remove the two screws that secure the solid-state drive.

4. Lift the solid-state drive out of its system board connector.

Replacing the Solid-state Drive

1. Remove the new drive from its packaging.

2. Insert the solid-state drive into the slot at a 45-degree angle.

3. Press the solid-state drive down and replace the two screws that secure the drive.

4. Replace the module cover (see

5. Slide the battery into the battery bay, until it clicks into place and slide the battery-lock latch towards the lock position.

Turning Off Your

Begin.

Removing the Module

Cover).

solid-state drive

Replacing the Module

Cover).

Computer) before removing the solid-state drive. Do not remove the solid-