Dell 1537 - Studio Core 2 Duo T6400 2.0GHz 4GB 320GB Service-Handbuch - Seite 29
Blättern Sie online oder laden Sie pdf Service-Handbuch für Desktop Dell 1537 - Studio Core 2 Duo T6400 2.0GHz 4GB 320GB herunter. Dell 1537 - Studio Core 2 Duo T6400 2.0GHz 4GB 320GB 42 Seiten. Dell laptop setup instruction
Auch für Dell 1537 - Studio Core 2 Duo T6400 2.0GHz 4GB 320GB: Setup-Handbuch (2 seiten), Einrichten Ihres Computers (2 seiten)
Seite drucken
Back to Contents Page
Memory
Dell™ Studio 1535/1536 Service Manual
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your Quick Reference Guide for information
on the memory supported by your computer. Install only memory modules that are intended for your computer.
NOTE:
Memory modules purchased from Dell™ are covered under your computer warranty.
Your computer has two user-accessible SODIMM sockets, DIMM A and DIMM B, accessed from the bottom of the computer.
NOTICE:
If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMM A" before you install a
module in the connector labeled "DIMM B."
Removing Memory Module(s)
The memory modules are located under the base cover on the computer.
1. Follow the procedures in
Before You
2. Turn the computer over and remove the base cover (see
NOTICE:
To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
3. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
4. Remove the module from the connector.
1
securing clips (2)
Replacing Memory Module(s)
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
1. Align the notch in the module edge connector with the tab in the connector slot.
2. Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not hear the click, remove the
module and reinstall it.
NOTE:
If the memory module is not installed properly, the computer may not boot. No error message indicates this failure.
Begin.
Removing the Base
2
memory module
Cover).