ENSOTECH SWAVE-W Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kabel und Anschlüsse ENSOTECH SWAVE-W herunter. ENSOTECH SWAVE-W 11 Seiten. Electronic speed controller
Auch für ENSOTECH SWAVE-W: Handbuch (11 seiten)

Seite drucken

HARDWARE IS YOUR EXCELLENCE

SOLDERING THE CABLE

-DO NOT OVERHEAT SOLDER TABS, consider of small size electronics components are very sensitive and easy to

damage by over heat, Ensotech recommend it should not soldering each connection point more than 1 second with

maximum of 300 degree Celsius. Beside, please make sure the cable and soldering material are well covered the

conductive surfaces as possible, and fully isolated from any other conductive surfaces.

If weak connecting of conductive surfaces cause the ESC failure, it is not under warranty.

Better soldering work gives advantage of decrease the electronic resistance, the calibration beep sound become

launder and the ESC will perform better performance.

HOOKUP INSTRUCTION

Connect "sensor cable" – a cable between ESC and Ensotech certified sensored motors.

Connect "receiver cable" – a cable between ESC and receiver. We have included two different types of cable plug (JR

& JST) for different receivers.

The motor should be well and properly soldered to the ESC. This is very valuable for getting full performance from the

system and reduce heating.

MTR

Swave E2/W

Connection

Diagram

WWW.ENSOTECH.LTD

Unit F, 6 Floor, Cheung Hing Shing Centre, No.23, Sha Tsui Road, Tsuen Wan,

Battery

New Territories, Hong Kong

Hall

Throttle

Uart

Android

Link

Receiver

Smartphone