Dell E05B001 Referenzhandbuch - Seite 19

Blättern Sie online oder laden Sie pdf Referenzhandbuch für Server Dell E05B001 herunter. Dell E05B001 29 Seiten.

Seite drucken

Option

Description

External Serial

Enables you to associate the External Serial Connector to Serial Device 1, Serial Device 2, or the

Connector

Remote Access Device by using this option. This option is set to Serial Device 1 by default.

Enables you to associate the External Serial Connector to Serial Device 1.

Failsafe Baud

Specifies the failsafe baud rate for console redirection. The BIOS attempts to determine the baud rate

Rate

automatically. This failsafe baud rate is used only if the attempt fails, and the value must not be changed.

This option is set to 115200 by default.

Remote Terminal

Sets the remote console terminal type. This option is set to VT100/VT220 by default.

Type

Redirection After

Enables or disables the BIOS console redirection when the operating system is loaded. This option is set

Boot

to Enabled by default.

System Profile Settings

You can use the System Profile Settings screen to enable specific system performance settings such as power management.

Viewing System Profile Settings

To view the System Profile Settings screen, perform the following steps:

Steps

1. Power on, or restart your system.

2. Press F2 immediately after you see the following message:

F2 = System Setup

NOTE:

If your operating system begins to load before you press F2, wait for the system to finish booting, and then

restart your system and try again.

3. On the System Setup Main Menu screen, click System BIOS.

4. On the System BIOS screen, click System Profile Settings.

System Profile Settings details

About this task

The System Profile Settings screen details are explained as follows:

Option

Description

System Profile

Sets the system profile. If you set the System Profile option to a mode other than Custom, the BIOS

automatically sets the rest of the options. You can only change the rest of the options if the mode is

set to Custom. This option is set to Performance Per Watt Optimized (DAPC) by default. DAPC is

Dell Active Power Controller.Other options include Performance Per Watt (OS), Performance, and

Workstation Performance.

NOTE:

You can use only Serial Device 2 for the Serial Over LAN (SOL) feature. To use console

redirection by SOL, configure the same port address for console redirection and the serial device.

NOTE:

Only Serial Device 2 can be used for Serial Over LAN (SOL). To use console redirection by

SOL, configure the same port address for console redirection and the serial device.

NOTE:

Every time the system boots, the BIOS syncs the serial MUX setting saved in iDRAC. The

serial MUX setting can independently be changed in iDRAC. Loading the BIOS default settings from

within the BIOS setup utility may not always revert this setting to the default setting of Serial Device

BIOS and UEFI