Dell EMC PowerEdge C6420 Referenzhandbuch - Seite 25

Blättern Sie online oder laden Sie pdf Referenzhandbuch für Server Dell EMC PowerEdge C6420 herunter. Dell EMC PowerEdge C6420 26 Seiten.

iDRAC Settings utility

The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI. You can enable or disable

various iDRAC parameters by using the iDRAC settings utility.

NOTE:

Accessing some of the features on the iDRAC settings utility needs the iDRAC Enterprise License upgrade.

For more information about using iDRAC, see Dell Integrated Dell Remote Access Controller User's Guide at

poweredgemanuals.

Device Settings enables you to configure the below device parameters:

● Controller Configuration Utility

● Embedded NIC Port1-X Configuration

● NICs in slotX, Port1-X Configuration

● BOSS Card configuration

Dell Lifecycle Controller (LC) provides advanced embedded systems management capabilities including system deployment,

configuration, update, maintenance, and diagnosis. LC is delivered as part of the iDRAC out-of-band solution and Dell system

embedded Unified Extensible Firmware Interface (UEFI) applications.

The Dell Lifecycle Controller provides advanced embedded system management throughout the lifecycle of the system. The Dell

Lifecycle Controller can be started during the boot sequence and can function independently of the operating system.

NOTE:

Certain platform configurations may not support the full set of features provided by the Dell Lifecycle Controller.

For more information about setting up the Dell Lifecycle Controller, configuring hardware and firmware, and deploying the

operating system, see the Dell Lifecycle Controller documentation at www.dell.com/poweredgemanuals.

The Boot Manager screen enables you to select boot options and diagnostic utilities.

About this task

To enter Boot Manager:

Steps

1. Power on, or restart your system.

2. Press F11 when you see the following message:

F11 = Boot Manager

If your operating system begins to load before you press F11, allow the system to complete the booting, and then restart your

system and try again.

Pre-operating system management applications