Dell EMC PowerProtect DD6400 System Erweiterung Manuallines - Seite 13
Blättern Sie online oder laden Sie pdf Erweiterung Manuallines für Server Dell EMC PowerProtect DD6400 System herunter. Dell EMC PowerProtect DD6400 System 46 Seiten.
Seite drucken
Figure 5. CMA arm and separator
Install the rails
About this task
The rails are labeled left and right, and cannot be interchanged. The front side of each rail is labeled Left Front or Right Front
when viewed from the cabinet front.
Steps
1. Determine where to mount the system, and use masking tape or a felt-tip pen to mark the location at the front and back of
the cabinet.
NOTE:
Install the left rail assembly first.
2. Fully extend the rear sliding bracket of the rail.
3. Position the rail end piece labeled Left Front facing inward and orient the rear end piece to align with the holes on the rear
cabinet flanges.
4. Push the rail straight toward the rear of the rack until the latch locks in place.
Figure 6. Installing the rear end of the rail
5. For the front end piece, rotate the latch outward and pull the rail forward until the pins slide into the flange, and release the
latch to secure the rail in place.
Install the System in the Rack
13