Allied Telesis AT-8948 So konfigurieren Sie - Seite 4

Blättern Sie online oder laden Sie pdf So konfigurieren Sie für Software Allied Telesis AT-8948 herunter. Allied Telesis AT-8948 9 Seiten. At-8900 series
Auch für Allied Telesis AT-8948: Datenblatt (4 seiten), Datenblatt (3 seiten), Datenblatt (3 seiten), Datenblatt (2 seiten), Datenblatt (5 seiten), Übersicht (1 seiten), Broschüre (8 seiten), Ergänzendes Handbuch (6 seiten), Handbuch zur Schnellinstallation (13 seiten)

Core 1 (master) configuration

1. Name the switch

2. Create the new VLANs

Create VLANs 2 and 3 for the LANs off distribution switches 2 and 3. The LAN off

distribution switch 1 will use VLAN 1.

3. Configure STP

STP is necessary because each distribution switch forms a loop with the two core switches.

By default, all VLANs belong to the default STP, so we do not need to add VLANs to the STP.

4. Add ports to the VLANs as tagged ports

5. Stop all ports from being untagged ports in VLAN 1

6. Aggregate ports 23-24

The amount of traffic going across the inter-core link depends on the load balancing process

being used by the servers. If they use teaming NICs, and some traffic goes via the NIC that is

connected to the VRRP backup, then that traffic will go from the server to the backup switch

to the master switch to the client (and vice versa). In these circumstances, a lot of traffic

could pass between the master and backup switches, so that link needs to be an aggregated

set of ports.

Page 4 | AlliedWare™ OS How To Note: VRRP

set system name=master

create vlan=vlan2 vid=2

create vlan=vlan3 vid=3

...

enable stp=default

set stp=default priority=8192 mode=rapid

set vlan=1 port=1,23-24 frame=tagged

add vlan=2 port=2,23-24 frame=tagged

add vlan=3 port=3,23-24 frame=tagged

...

delete vlan=1 port=1-24

create switch trunk=example port=23-24

Core 1 (master) configuration