Dell Force10 S25P Handbuch - Seite 37
Blättern Sie online oder laden Sie pdf Handbuch für Server Dell Force10 S25P herunter. Dell Force10 S25P 48 Seiten. Installing the s25p system
Auch für Dell Force10 S25P: Schnellstart-Handbuch (27 seiten)
Seite drucken
Waste Electrical and Electronic Equipment (WEEE) Directive for Recovery,
Recycle and Reuse of IT and Telecommunications Products
Force10 switches are labeled in accordance with European Directive 2002/96/EC concerning waste
electrical and electronic equipment (WEEE). The Directive determines the framework for the return and
recycling of used appliances as applicable throughout the European Union. This label, as shown in
Figure 21 on page 37
but rather reclaimed upon end of life per this Directive.
Figure 21 The European WEEE symbol
In accordance with the European WEEE Directive, electrical and electronic equipment (EEE) is to be
collected separately and to be reused, recycled, or recovered at end of life. Users of EEE with the WEEE
marking per Annex IV of the WEEE Directive, as shown above, must not dispose of end of life EEE as
unsorted municipal waste, but use the collection framework available to customers for the return, recycling
and recovery of WEEE. Customer participation is important to minimize any potential effects of EEE on
the environment and human health due to the potential presence of hazardous substances in EEE.
Force10 Networks products, which fall within the scope of the WEEE, are labeled with the crossed-out
wheelie-bin symbol, as shown above, as required by WEEE.
For information on Force10 product recycling offerings, see the WEEE Recycling instructions on iSupport
at: https://www.force10networks.com/CSPortal20/Support/WEEEandRecycling.pdf.
For more information, contact the Force10 Technical Assistance Center (TAC) (see
Technical Assistance Center on page
Notice to Recyclers
To open the case:
1
Remove the small phillips screws that connect the top to the body. There should be three evenly spaced
across the rear and three evenly spaced along each side.
2
Slide the top backwards until its front flange slides free of the faceplate, then lift it off.
To remove the lithium closed-cell clock battery (clearly visible towards the right rear of switch):
1
Insert a small, flat screw driver blade under the battery and in one of the slots of the plastic retainer
underneath the battery.
2
Lever the battery up against the coin cell clip (the hold-down lead on top of the battery) far enough to
provide room for the battery to be lifted above the edge of its retainer, as shown in the photograph,
below.
Installing the S25P System
is applied to various products to indicate that the product is not to be thrown away,
41).
Contacting the
37