EarthCore PET-30P Benutzerhandbuch - Seite 13

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Innenkamin EarthCore PET-30P herunter. EarthCore PET-30P 18 Seiten.

Seite drucken

FOR YOUR SAFETY, READ BEFORE LIGHTING

Warning: If you do not follow these instructions exactly, a ﬁ re or explosion may result, causing

property damage, personal injury, or loss of life.

Do not use this appliance if any part has been underwater. Immediately call for a qualiﬁ ed professional

service technician to inspect the appliance and to replace any part of the control system and any gas

control that has been underwater.

BEFORE LIGHTING, smell all around the burner area for gas. Be sure to smell next to the ﬂ oor, as some

gas is heavier than air and will settle on the ﬂ oor. IF YOU SMELL GAS, FOLLOW THE INSTRUCTIONS

ON PG. 1.

LIGHTING

1. Turn off any electrical appliance.

2. When operating remotely; ﬂ ip the remote receiver control

to the REMOTE position, and turn the unit ON by using

the remote transmitter.

3. Alternately; ﬂ ip the receiver switch to the ON position when

manually operated. This transmits a rapid series of sparks

at the pilot head and will ignite the gas.

Sparks cease when the pilot ﬂ ame is lit and stable. after a short

time, the pilot will then light the main burner.

CAUTION: IF THE BURNER DOES NOT IGNITE WITHIN

20 SECONDS, STOP WAIT 5 MINUTES, THEN

REPEAT STEPS 1. THRU 3. ABOVE.

Normally, the pilot should remain lit. If it goes out, repeat step

2 or 3.

If the pilot will not stay lit after several tries, turn the receiver

to OFF and contact a qualiﬁ ed professional service technician

or gas supplier.

In addition to these instructions; reference the separate remote

instructions for further details on the remote system.

If optional wall switch was purchased separately; refer to the

instructions supplied with the wall switch for lighting/operation.

PILOT APPEARANCE

Periodically check the pilot for proper ﬂ ame pattern. The pilot

ﬂ ame should encircle the generator tip, and is preset at the

factory (see Fig. 13-2).

If the pilot ﬂ ame burns incorrectly; shut down completely

and contact a qualiﬁ ed professional service technician.

SHUTTING DOWN

1. Simply ﬂ ip the receiver switch to the OFF position when

manually operated. The gas ﬂ ow will cease, and all the

ﬂ ames (main burner and pilot) will go out.

2. For remote operation, press the OFF button on the

transmitter.

LIGHTING INSTRUCTIONS

ADJ.

LEARN

OFF

REMOTE

Fig. 13-1 Receiver & Transmitter

Fig. 13-2 Proper pilot ﬂ ame

OFF