Dell 1501FP Handbuch zur Schnelleinrichtung
Blättern Sie online oder laden Sie pdf Handbuch zur Schnelleinrichtung für Monitor Dell 1501FP herunter. Dell 1501FP 4 Seiten. Dell flat panel color monitor quick set-up guide
Seite drucken
Observe the following safety guidelines when connecting and using your monitor:
Be sure your monitor is electrically rated to operate with the AC power available in your location.
Locate your monitor near an easily accessible electrical outlet.
Place the monitor on a solid surface and treat it carefully. The screen can be damaged if dropped, sharply hit, or
touched with a sharp or abrasive implement.
Put your monitor in a location with low humidity and a minimum of dust.
Never use your monitor if the power cable has been damaged. Do not allow anything to rest on the power cable, and
keep the cable away from where people could trip over it.
Never insert anything metallic into the monitor openings. Doing so may create the danger of electric shock.
To avoid electric shock, never touch the inside of the monitor. Only a qualified technician should open the monitor's
case.
Be sure to hold the plug, not the cable, when disconnecting the monitor from an electrical outlet.
Openings in the monitor cabinet are provided for ventilation. To prevent overheating, these openings should not be
blocked or covered. Also, avoid using the monitor on a bed, sofa, rug, or other soft surface. Doing so may block the
ventilation openings in the bottom of the cabinet. If you put the monitor in a bookcase or some other enclosed space,
be sure to provide adequate ventilation.
Do not expose the monitor to rain or use it near water. If the monitor accidentally gets wet, unplug it and contact
an authorized dealer immediately. You can clean the exterior of the monitor with a damp cloth when necessary, but
be sure to unplug the monitor first.
If your monitor does not operate normally—in particular, if there are any unusual sounds or smells coming from it—
unplug the monitor immediately and contact an authorized dealer or service center.
3
5
1.
Turn off your computer and unplug your computer's power cord.
2.
DVI-D cable (with white connector) has to be connected to the back of your monitor.
3.
Attach the other end of DVI-D signal cable to digital output port on the back of your computer for digital video
connection.
4.
Connect power cord of your monitor to the power port on the back of the monitor.
5.
Plug power cords of your computer and your monitor into a nearby outlet.
6.
Turn on your monitor and computer.
7.
If your monitor displays an image, installation is complete. If it does not display an image, refer to the trouble-
shooting section of this guide.
2
4