Dell EqualLogic PS Series Hardware-Benutzerhandbuch - Seite 25
Blättern Sie online oder laden Sie pdf Hardware-Benutzerhandbuch für Lagerung Dell EqualLogic PS Series herunter. Dell EqualLogic PS Series 50 Seiten. Storage arrays
Auch für Dell EqualLogic PS Series: Einrichten (2 seiten), Hardware-Benutzerhandbuch (48 seiten), Wartung der Hardware (46 seiten)
Seite drucken
PS6610 Hardware Owner's Manual
Control module failover occurs automatically, and if iSCSI initiators reconnect to the group IP
address, application I/O can continue without user intervention.
Control Module Firmware Maintenance
Each control module has a microSD card running the array firmware. You should run the latest
firmware version to take advantage of new product features and enhancements.
In a dual control module array, both control modules must be running the same firmware ver-
Caution:
sion; otherwise, only one control module will be functional. You must update the controller with the
older version firmware to the same version as the active controller before you update the member to a
later version.
Group members should run the same firmware version; otherwise, only the functionality common to all
versions will be available in the group. See the PS Series Release Notes for information about mixed-
firmware groups.
If you are adding a second control module, upgrading a control module, or replacing a failed microSD
card, contact your PS Series support provider, which is in most cases Dell EqualLogic Technical
Support. Inform your provider of the current PS Series firmware version on your system. If you are
replacing a failed control module, remove the microSD card from the failed control module and install
it in the replacement control module. Installing the card ensures that you keep the correct firmware.
See
Replace the MicroSD Card on page
To display the firmware version running on an array, examine the GUI group member Controllers tab
or use the following CLI command:
member select show controllers
If the firmware on a microSD card does not match the firmware running on an array, do not install it.
Instead, contact your array support provider.
Control Module Handling Requirements
Follow these control module handling requirements:
• Do not remove an active control module.
• Protect control modules from electrostatic discharge. Always wear an electrostatic wrist strap
when handling a control module. See
• Do not remove a control module from an array while the control modules are synchronizing.
When synchronization completes, a console message will appear. Also, the ACT LED on the
secondary control module will be orange.
• Do not leave a control module slot empty. In an array with one control module, always attach a
blank faceplate to the empty control module slot.
• Store control modules properly. Store a control module in its original packaging or in an
antistatic bag or place the control module on a surface protected from electrostatic discharge.
About the Standby On/Off Button
The Type 18 control module has a small, recessed button labeled STANDBY ON/OFF located next to
the management port (see
25.
Hardware Protection on page
Figure
13). The button is recessed to prevent accidental activation.
3 Control Module Maintenance
6.
19