Dell PowerEdge 5160 Installationshandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Installationshandbuch für Lagerung Dell PowerEdge 5160 herunter. Dell PowerEdge 5160 36 Seiten. Installing the external drive bay
Auch für Dell PowerEdge 5160: Installationshandbuch (42 seiten), Installationshandbuch (20 seiten), Installationshandbuch (28 seiten), Handbuch aktualisieren (8 seiten), Information Update (8 seiten), Benutzerhandbuch (42 seiten), Rack-Einbau (34 seiten), Hardware-Installationshandbuch (40 seiten)

Seite drucken
Dell PowerEdge 5160 Installationshandbuch
support.dell.com
7 .
Attach the locking bar to the front of the drive bay assembly.
a.
Insert the bottom end of the locking bar (the end without the screw hole)
into the slot at the bottom-front of the assembly.
b.
Pivot the locking bar up so that the recessed hole at the top of the bar aligns
with the screw hole at the top of the assembly, and secure the locking bar
with the flush-mount screw.
Installing the External Drive Bay
To install the external drive bay, use the following procedure:
1.
Shut down the system, turn off the computer and any attached peripherals, and
disconnect the computer and peripherals from their electrical outlets.
2.
Remove the computer cover and front bezel.
See the Installation and Troubleshooting Guide for instructions on removing the
computer cover and front bezel.
3.
Slide the drive bay assembly into the external drive bay until it snaps into place.
NOTE: Step 4 describes one configuration for SCSI drives installed in the external
drive bay. For other configurations, see the Installation and Troubleshooting Guide.
4.
Attach the two connectors on the terminator end of the SCSI cable to the two
SCSI connectors on the back of the drive bay assembly, and attach the connector
on the other end of the cable to either the PRIMARY SCSI-A or PRIMARY SCSI-B
connector on the system board (see Figure 1-2).
Dell PowerEdge Systems — Installing the External Drive Bay
1-3