3 Day Blinds 2 1/2 Erste Schritte - Seite 3

Blättern Sie online oder laden Sie pdf Erste Schritte für Jalousien 3 Day Blinds 2 1/2 herunter. 3 Day Blinds 2 1/2 8 Seiten.

Seite drucken

OUTSIDE MOUNT

• Unwrap the cellophane from around the blind stack.

Caution: DO NOT cut the cellophane as the cords or ladders

supporting the blind may be inadvertently cut.

• Lower the blind to its full length. (See "Blind Operation".)

• Draw the blind completely up and set it aside.

• For 2" Wood & Faux Wood

& Angled Slat Blinds mount

the bracket using two of

the screws provided.

• Mount the bracket using the 2 screws provided.

• Repeat this procedurre for the right end bracket.

| 2 & 2

" Wood & Faux Wood & Angled Slat Blinds

• Hold the blind up to the

desired mounting position.

• Once the blind is level,

mark the wall at the lower

corners of each end of the

headrail using a pencil.

• Using a flathead

screwdriver, open the

latches of the end

brackets.

• Facing the window,

position the end bracket

marked "LH" above the

top left corner of the

window,

" TO THE LEFT

of the pencil marks.

• Using a pencil, mark the

wall through the holes

in the back of the end

bracket. For maximum

stability, the pencil

marks should be made

diagonally.

• Using a drill with a

" drill

bit or an awl, make a small

pilot hole at each pencil

mark.

• For 2

" Wood & Faux

Wood Blinds mount the

bracket using one spacer

block and two of the screws

provided.

TO INSTALL CENTER SUPPORT BRACKET(S):

If your hardware packet includes one center support

bracket, position it as close to the center of the mounting

surface as possible, making sure it will not interfere with

any moving parts. If more than one center support bracket

has been provided, position them equidistant from the end

brackets and each other, again avoiding all moving parts.

• For 2" Wood & Faux Wood

& Angled Slat Blinds, mount

the bracket using two of

the screws provided.

• Repeat this procedure for any remaining center support

bracket(s).

Proceed to "Valance Return Assembly".

• Make sure all center

support brackets are

positioned at the same

height and are level with

the end brackets.

• Using a pencil, mark the

mounting surface through

the holes in the back

of the center support

bracket. For maximum

stability, the pencil marks

should be made in the top

two holes of the center

support bracket.