Dell PowerVault NX1950 Upgrade-Handbuch - Seite 12

Blättern Sie online oder laden Sie pdf Upgrade-Handbuch für Lagerung Dell PowerVault NX1950 herunter. Dell PowerVault NX1950 18 Seiten. For vmware esx server software
Auch für Dell PowerVault NX1950: Handbuch für den Einsatz (34 seiten), Wichtige Informationen Handbuch (26 seiten), Erste Schritte (49 seiten), Handbuch für Installation und Fehlersuche (48 seiten), Handbuch für den Einsatz (38 seiten), Referenzhandbuch (4 seiten), Einrichten (2 seiten), Verwendung von (2 seiten), Konfigurationshandbuch (11 seiten)

Seite drucken
Dell PowerVault NX1950 Upgrade-Handbuch

Creating a New Target

Creating a New Target in a Clustered Environment

Perform the following steps to re-create the Targets and re-assign the .vhd files:
1 Create a highly available iSCSI instance:
In the Microsoft Management Console, right-click the Microsoft
a
iSCSI Software Target icon and click Create HA instance for iSCSI.
Type the desired name in the Resource Group Name filed and click
b
Add. Enter the remaining required fields:
•
IP Address
•
Subnet mask
•
Network Interface
Click OK and click OK again.
c
The highly available iSCSI instance is created successfully.
d
2 Perform the following steps to configure the iSCSI Initiator to discover
the Target:
In the Discovery tab of the iSCSI Initiator, add the IP address of the
a
newly created highly available iSCSI instance. Click Advanced and
configure the following properties:
•
Local Adapter—Microsoft iSCSI Initiator
•
Source IP—IP address of the client for iSCSI traffic
If you are using iSNS server, go to the Microsoft Management Console→
b
right-click Microsoft iSCSI Software Target→ Properties→ iSNS tab
and add the iSNS IP address.
In the Discovery tab, go to Initiator and add iSNS IP address.
c
3 To configure the Target:
In the Microsoft Management Console, right-click on the
a
Microsoft iSCSI Software Target icon and click Create iSCSI Target.
Enter the Target name, Target description, and click Next.
b
Browse for the desired IQN identifier or click Advanced→ Add→
c
IP address and enter the IP address of the Initiator. Click Next.
12
Configuring 3.1 Target