Earthlite Ellora Salon Top Benutzerhandbuch - Seite 11

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Inneneinrichtung Earthlite Ellora Salon Top herunter. Earthlite Ellora Salon Top 20 Seiten. Electric lift table

Seite drucken

Once your table is placed safely on the floor, temporarily plug the table into a power outlet and using the

foot control, raise the table to waist height, which will make it easier for moving. Once the table is at the

desired height, unplug the power cable from the outlet and place the power cable along with the foot

control on top of the table to prevent a tripping hazard. For ease of movement and flexibility, your table

was built with two (2) rear wheels and two (2) front foot glide levers.

The following steps will guide you through safely moving your table to the desired location. We

recommend that at least two (2) people conduct the following steps:

Step 1

Locate the front and rear sections of the table frame underneath the upholstered top as designated by

the black arrows above. These are the recommended locations to hold when guiding your table to the

desired location (Diagram A1).

Note Regarding Step 1:

Locate the front crossbar of the table frame where the foot glide levelers are located (Diagram

A2). This is a secondary recommended section of the frame to hold if you prefer, but may be more

difficult. If you choose this location, properly bend at your knees prior to lifting or pulling the table.

Step 2

Ensure there are no obstacles or tripping hazards in the way and carefully pull the table by the frame

into the desired location (Diagram B). A second person's assistance is recommended to help push the

table from the opposite end.

Not all commercial and residential floors are perfectly level. The Ellora

swivel into place against the floor. If your table is not already level when you remove it from the

shipping crate, follow these easy steps to level your table:

Step 1

Locate which foot glide leveler

is not even with the floor.

PLACEMENT AND INSTALLATION

Do NOT pull or push the table from the upholstered top. Moving the table in this

fashion can damage the table and put too much pressure on hinges or other

components of the table. Damage made to the table by pulling or pushing on

the upholstered top may void the warranty (Diagram C).

Install this furnishing in treatment area not accessible to the public.

SAFETY ZONE: The treatment area must have 3-ft minimum unobstructed

clearance around entire table. Posting a notice is recommended to maintain

"Safety Zone Clearance" . The designated work area around the table should

be clearly marked off.

Step 2

Rotate the foot glide leveler

clockwise or counter clockwise

to bring it to ground level.

LEVELING THE TABLE

™

has foot glide levelers that

Step 3

Once the foot glide leveler is tight

with the floor, apply pressure on

top of the table to confirm stability.