Dell Force10 S4810 Handbuch für den Einsatz - Seite 14
Blättern Sie online oder laden Sie pdf Handbuch für den Einsatz für Schalter Dell Force10 S4810 herunter. Dell Force10 S4810 36 Seiten. Dell force10 s4810 switch
Auch für Dell Force10 S4810: Schnellstart-Handbuch (27 seiten), Konfigurationshandbuch (17 seiten), Konfigurationshandbuch (17 seiten)
Seite drucken
Controller 2
: -
Port List
:
Te 0/7 (8), Te 0/31 (32)
Vlan List
:
Vlan Mbr list
:
To display information for the second OF instance, use the show running-config openflow of-instance
2 command:
FTOS# show running-config openflow of-instance 2
!
openflow of-instance 2
controller 1 10.11.205.184
flow-map l2 enable
flow-map l3 enable
interface-type vlan
learning-switch-assist enable
multiple-fwd-table enable
no shutdown
FTOS#show openflow of-instance 2
Instance
: 2
Admin State
: Up
Interface Type
: Vlan
DP Id
: 00:02:00:01:e8:8b:1a:30
Forwarding Tbls : acl,mac,route
Flow map
: l2,l3
LB assist
: enabled
EchoReq interval: 15 seconds
Connect interval: 15 seconds
Number of Flows : 0
Packets (acl)
: -
Bytes (acl)
: -
Controller 1
: TCP, 10.11.205.184/6633, connected (equal)
Controller 2
: -
Port List
:
Vlan List
:
Vl 200
Vlan Mbr list
:
Te 0/0 (1), Te 0/1 (2)
ACL Flows
By default, all flows are treated as ACL flows. No additional configuration is required to set up ACL flows. You can view
per-flow and aggregate statistics for ACL flows using the show openflow of-instance and show openflow
flows of-instance commands.
To clear these statistics, use the clear openflow statistics of-instance command . The following
sample ACL flow was configured using a controller. It matches by dmac, ether-type, ip-protocol, and tcp-dst-port, then
sets the VLAN ID to 111 and forwards the packet from Te 0/31.
FTOS#show openflow flows of-instance 1
Instance: 1, Table: acl, Flow: 1, Cookie: 0xa000003c435722
Priority: 32768, Internal Priority: 32768
Up Time: 0d 00:02:34, Hard Timeout: 0 seconds
Idle Timeout: 0 seconds, Internal Idle Timeout: 0 seconds
Packets: 1, Bytes: 64
Match Parameters:
Valid Match: Etype,DMAC,IP proto,DPort
In Port
: *
SMAC
: *
VLAN id
: *
14
tcp
EType
: ip
DMAC
: 00:11:11:11:11:11
VLAN PCP
: *