Dell N1548P Anleitung zur Firmware-Aktualisierung - Seite 15
Blättern Sie online oder laden Sie pdf Anleitung zur Firmware-Aktualisierung für Schalter Dell N1548P herunter. Dell N1548P 17 Seiten. Emcnetworking switches
Seite drucken
- 1. Table of Contents
- 2. Introduction
- 3. Global Support
- 4. Firmware Upgrade Overview
- 5. Firmware Downgrade Overview
- 6. How to Access Serial Console on Dell EMC Networking N1500 Series Switches
- 7. Upgrade Example of Dell EMC Networking N1500 Series Switches
- 8. Upgrade Stack of Dell EMC Networking N1500 Series Switches
- 9. Switch Recovery Procedure
- 10. Switch Recovery Example
- 11. End of Document
Upgrade Dell EMC Networking N1500 Series Switches
The system is going down NOW!
Sent SIGTERM to all processes
Sent SIGKILL to all processes
Requesting system reboot
U-Boot 2012.10-00244-g9552470cd8 (Feb 20 2018 - 15:54:29)
I2C:
ready
BENCH SCREENING TEST1
=========================================
IPROC_XGPLL_CTRL_3: 0x05400000
IPROC_XGPLL_STATUS: 0x80000490
DCO code: 73
=========================================
DEV ID = 0xdb56
SKU ID = 0xb150
DDR type: DDR3
MEMC 0 DDR speed = 667MHz
PHY revision version: 0x00024006
ddr_init2: Calling soc_ddr40_set_shmoo_dram_config
ddr_init2: Calling soc_ddr40_phy_calibrate
C01. Check Power Up Reset_Bar
C02. Config and Release PLL from reset
C03. Poll PLL Lock
C04. Calibrate ZQ (ddr40_phy_calib_zq)
C05. DDR PHY VTT On (Virtual VTT setup) DISABLE all Virtual VTT
C06. DDR40_PHY_DDR3_MISC
C07. VDL Calibration
C07.1
C07.2
C07.4
C07.4.1
C07.4.4
VDL calibration result: 0x30000003 (cal_steps = 0)
C07.4.5
C07.4.6
C07.5
C08. DDR40_PHY_DDR3_MISC : Start DDR40_PHY_RDLY_ODT....
C09. Start ddr40_phy_autoidle_on (MEM_SYS_PARAM_PHY_AUTO_IDLE) ....
C10. Wait for Phy ReadyDone.
DDR phy calibration passed
Programming controller register
ddr_init2: MemC initialization complete
Validate Shmoo parameters stored in flash ..... OK
Press Ctrl-C to run Shmoo ..... skipped
Restoring Shmoo parameters from flash ..... done
Running simple memory test ..... OK
DeepSleep wakeup: ddr init bypassed 3
DDR Interface Ready
CPLD: addr=0x21, rev=10
Board: L2 48 Port Copper POE+ Switch, X01
DRAM:
1 GiB
NAND:
Micron MT29F1G08ABADA, 128 KiB blocks, 2 KiB pages, 16B OOB, 8-bit
NAND:
chipsize 128 MiB
In:
serial
Out:
serial
Err:
serial
arm_clk=1000MHz, axi_clk=400MHz, apb_clk=100MHz, arm_periph_clk=500MHz
Page 13