Dell N2048 Firmware-Upgrade - Seite 7

Blättern Sie online oder laden Sie pdf Firmware-Upgrade für Schalter Dell N2048 herunter. Dell N2048 21 Seiten.
Auch für Dell N2048: Installationshandbuch (49 seiten)

Seite drucken

1. How to Access Serial Console on N2000/N3000 Series Switches

Upgrade Procedure Dell™ Networking

N2024/N2024P/N2048/N2048P/N3024/N3024F/N3024P/N3048/N3048P

Switches

How to Access Serial Console on N2000/N3000 series switches

NOTE:

How to access serial console of the N3000 Series switch? Use a supplied "RJ45 Yost to DB9

serial cable" to access the serial console. Connect the RJ45 end of the cable to the RJ45 serial console port

and the DB9 connector to your PC. Download and Install the terminal emulation software on your PC (for

example., PuTTY) to access the serial console with the correct settings (default setting 9600 baud, 8 data

bits, no parity bit, 1 stop bit, and no flow control).

Figure.1 N3048 with 48 10/100/1000BASE-T Ports (Front Panel)

NOTE:

How to access serial console of the N2000 Series switch? Use a supplied "RJ45 Yost to DB9

serial cable" to access the serial console. Connect the RJ45 end of the cable to the RJ45 serial console port

and the DB9 connector to your PC. Download and Install the terminal emulation software on your PC (for

example., PuTTY) to access the serial console with the correct settings (default setting 9600 baud, 8 data

bits, no parity bit, 1 stop bit, and no flow control).

NOTE:

N2000 switches do not have an out-of-band interface.

Figure.2 N2048 Switch with 48 10/100/1000BASE-T Ports (Front Panel)

NOTE:

By default, no network information is configured. The DHCP client is enabled on the OOB

interface by default on N3000 and N4000 switches. The DHCP client is enabled on VLAN 1 by default on

the N2000 switches. DNS is enabled, but no DNS servers are configured. VLAN 1 does not have an IP

address, subnet mask, or default gateway configured on N3000 and N4000 switches. You can assign an IP

address or IPv6 addresses to the OOB management port and to any VLAN. By default, all ports are

members of VLAN 1. If you assign an IP address to VLAN 1, you can connect to the switch management

interface by using any of the front-panel switch ports. This is required to manage the N2000 switches over

an Ethernet port.

RJ-45 serial console port

Page 4

O u t - o f - B a n d M a n a g e m e n t P o r t