Dell N2128PX-ON Aktualisieren von Software und Firmware - Seite 9
Blättern Sie online oder laden Sie pdf Aktualisieren von Software und Firmware für Schalter Dell N2128PX-ON herunter. Dell N2128PX-ON 14 Seiten.
Auch für Dell N2128PX-ON: Aktualisieren der Firmware (14 seiten)
Seite drucken
Upgrade Dell EMC Networking N2128PX-ON Switches
12. Power OFF both N2128PX-ON and N2000 Series switches. Plug-in mini-SAS stack cables and form the
stack between N2128PX-ON and N2000 Series switches.
13. Power ON stack (N2128PX-ON with N2000 Series).
14. Verify the stack of N2128PX-ON and N2000 Series switches via show switch and show version command
output like below:
Console#show switch
Management Standby
SW
Status
--- ---------- --------- ------------- ------------- ------------- -----------
1
Stack Mbr
2
Mgmt Sw
Console#show ver
Machine Description............... Dell EMC Networking Switch
System Model ID................... N2128PX-ON
Machine Type...................... Dell EMC Networking N2128PX-ON
Serial Number..................... CN0K2V1V2829872R0016
Manufacturer...................... 0xbc00
Burned In MAC Address............. 1418.7719.BE85
System Object ID.................. 1.3.6.1.4.1.4413
SOC Version....................... BCM56547_A0
HW Version........................ 3
CPLD Version...................... 8
Image File........................ N2100Stdv6.5.2.15
Software Capability............... Stack Limit = 12, VLAN Limit = 4093
unit active
---- ----------- ----------- -------------- --------------
1
6.5.2.15
2
6.5.2.15
Administrators setting up mixed stack of N2128PX-ON and N2000 Stacked switches should follow the below
steps below:
1. Back up your configuration of N2128PX-ON Stack and N2000 Stack Switches.
2. Upgrade using telnet or SSH require default enable authentication method or enable password in current
configuration. If not configured follow steps below to configure an enable password:
console#configure
console(config)#enable password <password>
console(config)#exit
console#copy running-config startup-config
3. Download the 6.5.2.15 firmware image (N2100Stdv6.5.2.15.stk) to stack of N2128PX-ON switches.
NOTE:
Activate the image to use as the boot (active) image after the stack
resets. Images on the N2128PX-ON stack is named as active and backup.
4. Activate 6.5.2.15 firmware on stack of N2128PX-ON switches.
5. Reload the N2128PX-ON Stack.
6. After stack reloaded, download and activate the mixed-stack firmware image
(N2000N2100Stdv6.5.2.15.itb) on stack of N2128PX-ON switches.
7. Reload the N2128PX-ON Stack again.
Preconfig
Status
Model ID
Oper Stby N2048P
N2128PX-ON
backup
current-active next-active
6.5.2.15
6.5.2.15
6.5.2.15
6.5.2.15
Plugged-in
Switch
Model ID
Status
N2048P
OK
N2128PX-ON
OK
6.5.2.15
6.5.2.15
Page 7
Code
Version
6.5.2.15
6.5.2.15