Dell Networking N4064 Konfigurationshandbuch - Seite 12

Blättern Sie online oder laden Sie pdf Konfigurationshandbuch für Schalter Dell Networking N4064 herunter. Dell Networking N4064 17 Seiten. Expansion modules for dell networking switches
Auch für Dell Networking N4064: Referenzhandbuch (17 seiten)

Seite drucken

Dell Networking N4064 Konfigurationshandbuch

Configure Data Center Bridging (DCB) (Optional)

DCB is enabled by default. This section shows the steps required to configure DCB.

Note: You must complete the Dell recommended switch configuration steps in Sections 2.1 to 2.12

before configuring the switch for DCB mode.

3.1

Enable DCB

If DCB was previously disabled, it must be manually re-enabled.

console#configure

console(config)#dcb enable

3.2

Create VLAN

console#configure

console(conf)# vlan vlan-id

Note: You must supply a VLAN id. The valid range is 2-4093.

console(conf)#exit

3.3

Configure class of service, dot1p mapping, and traffic class

console(config)#iscsi cos enable

console(config)#iscsi cos vpt 4

console(config)#classofservice dot1p-mapping 4 4

console(config)#classofservice traffic-class-group 4 1

3.4

Configure Priority flow control on switch ports and port channel

console(config)#interface range tengigabitethernet all

console(config-if)#datacenter-bridging

console(config-if-dcb)#priority-flow-control mode on

console(config-if-dcb)#priority-flow-control priority 4 no-drop

console(config-if-dcb)#exit

console(config-if)#switchport mode trunk

SCG1001

Dell Networking N4000 Series and Dell PowerConnect 8100 Series Configuration Guide