Dell PowerConnect 8024 Konfigurationshandbuch - Seite 13

Blättern Sie online oder laden Sie pdf Konfigurationshandbuch für Schalter Dell PowerConnect 8024 herunter. Dell PowerConnect 8024 21 Seiten. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Auch für Dell PowerConnect 8024: Anmerkungen zur Veröffentlichung (27 seiten), Anmerkungen zur Veröffentlichung (20 seiten), Aktualisieren der Firmware (24 seiten)

Seite drucken

Dell PowerConnect 8024 Konfigurationshandbuch

console(config)#ip http authentication local

console(config)#username admin password yourpassword privilege 15

console(config)#enable password yourpassword

3.9

Configure Jumbo Frames

console(config)#interface range tengigabitethernet all

console(config-if)#mtu 9216

console(config-if)#exit

3.10

Enable flow control

console(config)#flowcontrol

This operation may take a few minutes.

Management interfaces will not be available during this time.

Are you sure you want to continue? (y/n)y

3.11

Configure spanning tree portfast on edge ports

console(config)#interface range tengigabitethernet 1/0/1-16

console(config-if)#spanning-tree portfast

console(config-if)#exit

3.12

Configure port channel for LAG

These commands configure the switch interconnect as a LAG.

console(conf)#interface port-channel 1

console(conf-if-po1)#mtu 9216

console(conf-if-po1)#exit

3.13

Configure SFP+ ports for LAG (M8024-k)

Note: The commands in this section assign the four built-in external 10Gb SFP+ ports to the Port

Channel on the M8024-k. If you have the M8024 switch, skip this step and proceed to Section 3.14.

console(conf)#interface range tengigabitethernet 1/0/17-20

SCG1008

PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs