Dell PowerConnect M6220 Aktualisieren der Firmware - Seite 10
Blättern Sie online oder laden Sie pdf Aktualisieren der Firmware für Schalter Dell PowerConnect M6220 herunter. Dell PowerConnect M6220 24 Seiten. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Auch für Dell PowerConnect M6220: Anmerkungen zur Veröffentlichung (27 seiten)
Seite drucken
Upgrading PowerConnect Switches from Version 2.x.x.x or 3.x.x.x or
4.x.x.x or 5.x.x.x to 5.1.9.3 Firmware
- # of sectors per FAT copy:
- # of FAT table copies:
- # of hidden sectors:
- first cluster is in sector #
- Update last access date for open-read-close = FALSE
PCI unit 0: Dev 0xb820, Rev 0x11, Chip BCM56820_B0, Driver BCM56820_A0
SOC unit 0 attached to PCI device BCM56820_B0
Adding BCM transport pointers
Configuring CPUTRANS TX
Configuring CPUTRANS RX
Instantiating /download as rawFs,
Formatting /download for DOSFS
Instantiating /download as rawFs, device = 0x20001
Formatting.../download: file system is marked clean, skipping check
OK.
<186> Apr 6 03:09:42 0.0.0.0-1 General[1073741072]: bootos.c(225) 1 %% Event(0xaaaaaaaa)
Instantiating RamCP: as rawFs,
Formatting RamCP: for DOSFS
Instantiating RamCP: as rawFs, device = 0x30001
RamCP:/
- disk check in progress ...
RamCP:/
- Volume is OK
OK.
(Unit 1 - Waiting to select management unit)>
Applying Global configuration, please wait ...
Applying Interface configuration, please wait ...
console>
6. After the switch has finished rebooting, log in and verify that the firmware has been updated to the
version using the show version command. A single switch will typically reboot in around two minutes. A
stack may take significantly longer to complete the upgrade process.
console#show version
System Description................ Dell Ethernet Switch
System Up Time.................... 0 days, 00h:02m:36s
System Contact....................
System Name.......................
System Location...................
Burned In MAC Address............. 5C26.0AB2.4327
System Object ID.................. 1.3.6.1.4.1.674.10895.3023
System Model ID................... PC8024
Machine Type...................... Powerconnect 8024
unit image1
---- ----------- ----------- -------------- --------------
1
4.2.1.3
7. The switch is now ready for normal operation. Verify the configuration and make any changes needed prior
to connecting the switch to the operational network.
NOTE:
After upgrading to the 5.1.9.3 firmware, one can emulate the earlier
firmware default behavior for privileged exec (enable) mode access by
setting the enable authentication method to enableList.
console(config)# line telnet
console(config)# enable authentication enableList
console(config)# exit
60
2
4
136
device = 0x20001
device = 0x30001
image2
current-active next-active
5.1.9.3
image2
image2
Page 7
5.1.9.3